Digi WB-10 User manual

2018-11-09 WB-10







SpecificationsandOperationManual


Model :WB-10




1stversion













Edition Month Year
1st Feb. 2018














SHANGHAITERAOKAELECTRONICCO.,LTD
TINGLININDUSTRYDEVELOPMENTALZONE
JINSHANCOUNTRY,SHANGHAICHINA
TEL:[phone]
FAX:[phone]

2018-11-09 WB-10


Notice
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference
that may cause undesired operation.
Attention that changes or modification not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
Note: This product has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This product generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If
this product does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
FCC RF Safety Caution statement:
To satisfy FCC RF exposure requirements for mobile and base station
transmission devices, a separation distance of 20 cm or more should be
maintained between the antenna of this device and persons during operation. To
ensure compliance, operation at closer than this transmitter must not
recommended. The antenna(s) used for this transmitter must not be co-located
or operating in conjunction with any other antenna or transmitter.
The device has been evaluated to meet general RF exposure requirement.






















2018-11-09 WB-10





TableofContent
1. General Layout.....................................................................................................................1
2. Feature....................................................................................................................................2
3. Operation Condition............................................................................................................2
4. External Connector..............................................................................................................3
4.1 PowerConnector................................................................................................................3
4.2 EthernetConnetor..............................................................................................................3
5. Physical layoutofElectricalConnection..........................................................................3


2018-11-09 WB-10
R&DDe
p
t.
©
2018SH
A
NGHAITE
R
AOKAELECTRONICCO.,
L
TD. 1of 3


1. GeneralLayout

2018-11-09 WB-10
R&DDe
p
t.
©
2018SH
A
NGHAITE
R
AOKAELECTRONICCO.,
L
TD. 2of 3






2. Feature

NetworkParameters
Networkstandard Wirelessstandard:IEEE802.11n,g,b
LAN standard: IEEE802.3, IEEE802.3u

Wirelesstransmission rate IEEE802.11n: 150MbpsMax;
IEEE802.11g: 54MbpsMax;
IEEE802.11b: 11MbpsMax
Numberof channels 1~11
FrequencyRange 2.4000~2.4835G
Transmitpower 15dBm
Antenna
Antennatype External antenna
Function Parameters
WIFImode Wirelessnetworkcard/ wirelessaccesspoint/ wireless
router
WDSFunction SupportWDSwirelessbridge


Wirelesssecurity
Wireless MAC addressfiltering
Wirelesssafetyfunctionswitch
64/128/152bitWEPencryption
WPA-PSK/WPA2-PSK,WPA/WPA2securitymechanism

Networkmanagement Remotewebmanagement
Profileimportand export
WEBsoftwareupgrade



3. Operation Condition
zOperating temperature: -20º C to 70º C
zOperatinghumidity: 10~90% RH (Non-condensing)
zStoragetemperature: -40ºC to80ºC
zStoragehumidity: 5~90%RH (Non-condensing)
zPowersupply: DC 5V 1A
zPower Consumption: 2.5WMax

2018-11-09 WB-10
R&DDe
p
t.
©
2018SH
A
NGHAITE
R
AOKAELECTRONICCO.,
L
TD. 3of 3










4. ExternalConnector

4.1 PowerConnector

z1 xDC JACK

4.2 Ethernet Connetor

z1 xRJ45: Connectwith PCorDIGIscale.



5. Physical layoutofElectrical Connection



