Digitus DN-95130 User manual

Gigabit PoE Mode Converter
User Manual
DN-95130
Description
DN-95130 is a PoE Mode Converter. It can be easily converter the PoE
power pin from mode A (1/2/3/5) to mode B (4/5/7/8) or the other way
around. No extra power needed. It is most efficient way to resolve PoE
power supply problem due to Power PIN support difference.
Based on the actual needs, for example, the PSE end is powered by
Mode B 4, 5, 7, and 8 cores, while the PD end requires mode A 1, 2, 3,
and 6 to power. Then just using one cable to connect mode B port as
marked, and the other end is converted to mode A, and using another
cable to connect the PD end.

Remark:
According to the standard of IEEE 802.11 af/IEEE 802.11 at, there are 2
modes for the PoE to supply the power:
Mode A: Powered by cable 1, 2, 3, and 6 cores (End-span)
Mode B: Powered by cable 4, 5, 7, and 8 cores (Mid-span)
Package Content
1x PoE Mode Converter
1x User Manual
Installation
1. Connect PSE PoE cable to corresponding POE mode A (1/2/3/6) or
B (4/5/7/8)
2. Connect PD to another side of DN-95130. You will get PoE mode
changed.
Left to Right (Change 1/2/3/6 PoE to 4/5/7/8 PoE)
PSE (1/2/3/6) PoE Mode Convertor PD (4/5/7/8)
Right to Left (Change 4/5/7/8 PoE to 1/2/3/6 PoE)
PSE (4/5/7/8) PoE Mode Convertor PSE (1/2/3/6)

Specification
Model DN-95130
Rate 10/100/1000Mbps (based on the rate of
the input device)
POE compatibility IEEE802.11af IEEE 802.11at
POE type PSE
POE output voltage 48-57VDC (Based on the input voltage)
POE output power 30W
POE PIN Assignment Mode A (1, 2, 3, 6) Mode B (4, 5, 7, 8)
Housing ABS
Dimension 145*60*40mm
Working Temperature 0-40
Store Temperature -40-85
Environment
Temperature 10%-90% RH, No condensation
Hereby Assmann Electronic GmbH, declares that the Declaration of Conformity is part of the
shipping content. If the Declaration of Conformity is missing, you can request it by post
under the below mentioned manufacturer address.
www.assmann.com
Assmann Electronic GmbH
Auf dem Schüffel 3
58513 Lüdenscheid
Germany