Digitus DA-70157 User manual

USB TO SERIAL RS485
CONVERTER
User Manual
(DA-70157)

Step 1: Insert CD Driver of this product to the CD-ROM
Step 2: Connect the device to a spare USB port on your PC, and find new hardware
wizard, please refer to the f ollowing chart:

Step 3: Select “No, not this time“, click “Next” to continue.
Step 4: Select “Install from a list or specific location (Advanced)”, click “Next” to continue.

Step 5: Select “Search removable media (floppy, CD-ROD…)”, click “Next” to continue.
Step 6: Auto search for the corresponding driver in the CD.

Step 7: You will find two types of hardware wizard, one is for USB 2.0 TO RS485
Converter, another one is for USB 2.0 TO RS485 cable. Please choose the
corresponding driver according to your product, click “Next” to continue.
Step 8: The wizard has started installation and copy file to your system

Step 9: Click “Finish” to close the wizard.
Step 10: Find new com port.

Step 11: Select “No, not this time“, click “Next” to continue.
Step 12: Select “Install from a list or specific location (Advanced), click “Next” to
continue.

Step 13: Select “Search removable media (floppy,CD-ROM…)”,click “Next” to continue.
Step 14: Auto search for the corresponding driver in the CD.

Step 15: Choose one type of the driver for your product, click “Next” to continue.
Step 16: The wizard has started installation and copy file to your system .

Step 17: Installation completed, click “Finish” to close the wizard.
Step 18: Your new hardware is installed and ready to use.