DIH Hocoma Andago User manual

Make sure you have read the user manual and watched the instructional
video before using the Andago V2.0 with patients. The video is available
on knowledge.hocoma.com
WE MOVE YOU
Andago®
QUICK
REFERENCE GUIDE

1. Place harness on patient
(check symmetry)
2. Turn Andago on
(next to rear right bumper)
3. Write down patient ID
(from screen)
1. Lift patient (until standing)
2. Adjust body weight support
3. Select default fall limit
(hold button)
1. Select training mode
(patient following /
straight line / manual)
2. Select speed limit
3. Start training
1. Stop training
2. Lower patient
3. Press Reset button 2 sec
(to save data)
4. Open harness and bring
patient out of Andago
PREPARATION
PATIENT
SETUP
TRAINING
FINISH SESSION
OPTIONAL STEPS
Patient Setup
1a. Select asymmet-
rical body weight
support
3a. Adjust fall limit
using patient lift
buttons
Training
3a. Adjust turning
offset
Holding the override
button activates
joystick at any time
AN_QRG_en_20180416