Dimplex DCTF10C User manual

For domestic household use only.
INSTRUCTION MANUAL
Bladeless DC Tower Fan
Model: DCTF10C

IMPORTANT
THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR
FUTURE REFERENCE. Note also the information presented on the appliance
CAUTION: FAILURE TO FOLLOW THESE INSTRUCTIONS MAY CAUSE INJURY AND/
OR DAMAGE AND MAY INVALIDATE YOUR WARRANTY
Please read the operating instructions carefully before using your fan for the rst time
and keep them in a safe place.
WARNING – This appliance must not be used in a bathroom.
WARNING – Do not use this appliance in the immediate surroundings of a bath, a
shower or a swimming pool.
• Never immerse the appliance in water or other liquids.
• Operate this unit only on a rm, at surface.
• Do not place on soft, unstable or non-horizontal/angled surfaces.
• Never operate the appliance if a cable or connector has been damaged, after
appliance malfunction or if the appliance was dropped or is otherwise damaged.
• If the mains lead is damaged it must only be replaced by the manufacturers service
agent or a similarly qualied person in order to avoid a hazard.
• Please ask a professional service agent to repair the product. Improper repair may
cause danger to users.
• Disconnect the appliance from mains power whenever it is not in use, before
relocating it, and before cleaning.
• Operate the appliance only at the voltage specied on the rating label.
• Only connect the unit to a properly installed and easily accessible socket so that
you can quickly disconnect the plug if necessary.
• Do not connect this product to the mains using an extension lead.
• This fan is only intended for INDOOR RESIDENTIAL applications. This fan should
not be used for commercial or industrial or leisure applications or in small enclosed
spaces.
• Never use the mains lead as a carrying strap or pulling lead.
• To avoid a re or electrocution hazard, NEVER put the cord near heat registers,
radiator, stoves or heaters.
• DO NOT cover cord with carpeting, throw rugs, runners, or similar coverings.
• DO NOT route cord under furniture or appliances. Take care to position the cord
away from trac areas and where it will not be a tripping hazard.
• DO NOT use the unit near windows or where water collects. Rain and water collection
may lead to a risk of re or electric shock.
• Only operate this appliance with a minimum of 50cm clearance all around i.e. away
from walls, furniture and overhanging objects such as curtains or a shelf.
• This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning use
of the appliance by a person responsible for their safety.
2

• Children should be supervised to ensure they do not play with the appliance.
• To prevent spillage, empty the water tank before lifting or relocating the appliance.
• WARNING: To avoid danger of suocation please remove all packaging materials
particularly plastic and EPS and keep these away from vulnerable people, children
and babies.
• NEVER drop or insert any object or ngers into any openings.
• Do not use the appliance in locations where paint, petrol or other ammable liquids
are used or stored.
• Do not use bug sprays or other ammable cleansers/vapour sprays on or around
the unit.
• Always switch o the unit and take the plug out of the socket:
• If you are not using the unit
• Before you clean or carry out maintenance on the unit
• If a fault occurs
• In the event of an electrical storm.
• Avoid electromagnetic interference. Keep the unit at least 1 metre away from
electrical appliances such as televisions & radios.
WARNING - KEEP BATTERIES OUT OF REACH OF CHILDREN
• Swallowing may lead to serious injury in as little as 2 hours or death, due to chemical
burns and potential perforation of the oesophagus.
• If you suspect your child has swallowed or inserted a button battery immediately
call the 24-hour Poisons Information Centre on 13 11 26 (in Australia) or 0800 764
766 (in New Zealand) for fast, expert advice.
• Examine devices and make sure the battery compartment is correctly secured,
e.g. that the screw or other mechanical fastener is tightened. Do not use if the
compartment is not secure.
• Dispose of used button batteries immediately and safely. Flat batteries can still be
dangerous.
3

Exposed to the
weather outdoors
Near water If the power cable
wires are frayed or cut
Where small children
may be left unattended
If an extension
lead may become
overloaded
Where there is risk
of re or close to
a naked ame
Where the power
cable may be
damaged
On a slope or
uneven surface
Where it may be
damaged by
chemicals
If there is a risk
of water falling on
the unit
Where there is a risk
of interference by
foreign objects
This product is not
made for DIY repair
4

Model no. DCTF10C
Colour Black
Power supply 220-240V~, 50Hz
Rated power 26W
Speed settings 9
Modes Sleep & Stong
Timer 0-8hr
Wind ow (max) 4.5m/s
Motor DC
Controls Touch or remote
Oscillation 90°
Noise level (max) 55dB(A)
Weight (net) 2.6kg
Dimensions (w x d x h) 230 x 230 x 960mm
Specication
• For greater precision, please always refer to the rating label placed on the product.
5

Parts
Air outlet
Remote storage
(magnetic)
LED Display
Base
Power cord
Air inlet
Remote receiver
Remote
6

Assembly
This tower fan comes fully assembled. Please remove any packing materials prior to
rst use.
Remote Control
A CR2025 button battery will already be inserted in the
remote. Should the battery need to be replaced, follow the
below instructions.
• Use a screwdriver or similar tool to turn the battery
cover anti-clockwise towards the word 'open'.
• Remove the old battery and discard appropriately.
NOTE: Button batteries are a swallowing hazard for
small children, so caution should be taken.
• Replaced with a new CR2025 battery, close the cover
and use the same tool to lock the cover in a clockwise
direction.
Modes
This fan is equipped with 2 x modes, as described below. These functions can only
be set with the remote control.
Strong Wind Mode
This mode is a boosted fan speed, and will provide the maximum airow. A 'H' will
appear on the display when activated.
Sleep Mode
When in this mode, the fan will deliver a quiet soft breeze for sleeping. An 'L' will
appear on the display when activated.
7

Operation
The remote for this tower fan stores magnetically on the top of the unit. It can be
operated when left in place, or removed and used as a remote.
Timer button
Oscillation button
Sleep mode button
Strong wind button
Remote Control
LED Display
Speed increase button
Speed decrease button
On/O button
The fan can also be controlled
by pressing the LED Display,
however not all settings can
be accessed this way.
Refer to the 'Operation'
section for instructions.
8

Operation
Note: You will hear a beep sound for every press of the button on the fan or remote
control. This cannot be turned o.
Remote Control Operation
1. Turn the fan On/O by pressing the On/O button.
2. Press the speed increase '+' & decrease '-' buttons to cycle through the speed
settings from 1-9. The selected speed setting will appear on the LED display.
3. The strong wind mode can only be turned on via the remote control. When this
mode is activated a 'H' will appear on the LED display screen. Press the speed
increase '+' or decrease '-' button to exit this mode.
4. The sleep mode can only be turned on via the remote control. When the sleep
mode button is pressed an 'L' will appear on the LED display screen. Press the
speed increase '+' or decrease '-' button to exit this mode.
5. Press the oscillation button to begin oscillation. Press the oscillation button again
to cancel oscillation.
6. This tower fan is equipped with a 1-8 hour auto o timer. Press the timer button
to set the timer in 1 hour increments, . The set time will briey appear on the LED
display. To cancel the timer, cycle through the hours set until '0' shows on the
display. Other settings can still be used when a timer is set.
LED Display Operation
Some functions can be operated by pressing the LED Display. To have full use of all
functions, please use the remote control.
1. Turn the fan On by pressing the LED Display screen for 1 second until you hear 1
beep. The fan will start working in the previous settings. To turn the fan o, press
and hold the LED display screen for 2 seconds until 2 beeps sound.
2. When the fan is already on, press the LED Display for 1 second to start oscillation
- 1 beep will sound. To stop oscillation, press the LED display for 1 second and the
fan will beep once and stop oscillating.
3. To adjust the fan speed, briey touch the LED Display to cycle through the
desired speed settings, a beep will sound for every speed change. The speed
setting will display on the screen.
NOTE: The LED Display turns o after 20 seconds. The display is activated again as
soon as a button is pressed.
9

Cleaning
Over time, dust can accumulate on the fan, which can aect the fans performance. It
is recommended to clean the fan at least once a month.
1. Turn the unit OFF and disconnect the appliance from the power supply.
2. Remove any dust build up with a soft brush. Taking care around the air outlet and
inlets.
3. Wipe the surface of the unit with a soft damp cloth. Mild detergent can be used
for any stubborn marks.
Do not use abrasive sponges, scouring pads, or a sti brush to clean the
IMPORTANT
The control panel and other parts must not come into contact with water or any
other liquids.
Storage
If not using the unit for an extended period of time. After cleaning please:
• Turn the unit o, unplug and take care of the mains lead & plug.
• Cover the unit and store it upright in a location where it will not receive direct sunlight.
NB- Prolonged exposure to direct sunlight will discolour the enclosure.
10

If the unit fails to operate eciently, is broken or other problems arise, unplug and
do not operate. Ask for advice by calling your local after sales service agent or the
Customer Care Centre on 1300 556 816 (AU) / 0800 666 2824 (NZ).
Maintenance
Recycling: Do not dispose of electrical appliances as unsorted
municipal waste. Use separate collection facilities. Contact your
local government for information regarding the collection systems
available. If electrical appliances are disposed of in landlls or dumps,
hazardous substances can leak into the ground water, polluting the
food chain and damaging health and well-being.
Warranty
Please refer to the warranty card in the box for warranty information. For any
troubleshooting advice, please contact the relative Customer Care Centre below.
Glen Dimplex Australia Pty Ltd Glen Dimplex New Zealand Ltd
1340 Ferntree Gully Road, 38 Harris Road, East Tamaki,
Scoresby 3179, Victoria Auckland 2013
Australia New Zealand
Ph: 1300 556 816 Ph: 0800 666 2824
11

Customer Care: 1300 556 816
[e-mail]
www.dimplex.com.au
Supplied by Glen Dimplex Australia
1340 Ferntree Gully Road, Scoresby, Victoria, 3179
© Glen Dimplex Australia. All rights reserved. Material contained in this publication may not be reproduced in whole or in part, without
prior permission in writing of Glen Dimplex Australia.
12