Dimplex DCPF40MB User manual

For domestic household use only.
INSTRUCTION MANUAL
40cm HV Pedestal Fan
Model: DCPF40C & DCPF40MB

IMPORTANT
THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR
FUTURE REFERENCE. Note also the information presented on the appliance
CAUTION: FAILURE TO FOLLOW THESE INSTRUCTIONS MAY CAUSE INJURY AND/
OR DAMAGE AND MAY INVALIDATE YOUR WARRANTY
Please read the operating instructions carefully before using your fan for the rst time
and keep them in a safe place.
WARNING – This appliance must not be used in a bathroom.
WARNING – Do not use this appliance in the immediate surroundings of a bath, a
shower or a swimming pool.
• Never immerse the appliance in water or other liquids.
• Operate this unit only on a rm, at surface.
• Do not place on soft, unstable or non-horizontal/angled surfaces.
• Never operate the appliance if a cable or connector has been damaged, after
appliance malfunction or if the appliance was dropped or is otherwise damaged.
• If the mains lead is damaged it must only be replaced by the manufacturers service
agent or a similarly qualied person in order to avoid a hazard.
• Please ask a professional service agent to repair the product. Improper repair may
cause danger to users.
• Disconnect the appliance from mains power whenever it is not in use, before
relocating it, and before cleaning.
• Operate the appliance only at the voltage specied on the rating label.
• Only connect the unit to a properly installed and easily accessible socket so that
you can quickly disconnect the plug if necessary.
• Do not connect this product to the mains using an extension lead.
• This fan is only intended for INDOOR RESIDENTIAL applications. This fan should
not be used for commercial or industrial or leisure applications or in small enclosed
spaces.
• Never use the mains lead as a carrying strap or pulling lead.
• To avoid a re or electrocution hazard, NEVER put the cord near heat registers,
radiator, stoves or heaters.
• DO NOT cover cord with carpeting, throw rugs, runners, or similar coverings.
• DO NOT route cord under furniture or appliances. Take care to position the cord
away from trac areas and where it will not be a tripping hazard.
• DO NOT use the unit near windows or where water collects. Rain and water collection
may lead to a risk of re or electric shock.
• Only operate this appliance with a minimum of 50cm clearance all around i.e. away
from walls, furniture and overhanging objects such as curtains or a shelf.
• This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning use
of the appliance by a person responsible for their safety.
2

• Children should be supervised to ensure they do not play with the appliance.
• WARNING: To avoid danger of suocation please remove all packaging materials
particularly plastic and EPS and keep these away from vulnerable people, children
and babies.
• NEVER drop or insert any object or ngers into any openings.
• Do not use the appliance in locations where paint, petrol or other ammable liquids
are used or stored.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualied persons in order to avoid a hazard.
• Do not use bug sprays or other ammable cleansers/vapour sprays on or around
the unit.
• Always switch o the unit and take the plug out of the socket:
• If you are not using the unit
• Before you clean or carry out maintenance on the unit
• If a fault occurs
• In the event of an electrical storm.
• Avoid electromagnetic interference. Keep the unit at least 1 metre away from
electrical appliances such as televisions & radios.
3

Exposed to the
weather outdoors
Near water If the power cable
wires are frayed or cut
Where small children
may be left unattended
If an extension
lead may become
overloaded
Where there is risk
of re or close to
a naked ame
Where the power
cable may be
damaged
On a slope or
uneven surface
Where it may be
damaged by
chemicals
If there is a risk
of water falling on
the unit
Where there is a risk
of interference by
foreign objects
This product is not
made for DIY repair
4

Model no. DCPF40C DCPF40MB
Colour
Chrome Matte Black
Power supply
220-240V~, 50Hz
Rated power 60W
Speed settings 3
Modes -
Timer -
Air volume 141m3/min
Adjustable height Yes - Max height 1.25m
Tilt adjustable head Y
Horizontal oscillation Y
Noise level 77dB(A)
Weight (net) 5.6kg
Dimensions (w x d x h) 450 x 410 x 1250mm
Specication
• For greater precision, please always refer to the rating label placed on the product.
5

Parts
7. Rotary switch
9. Motor housing
15. Base
14. Main pillar
13. Fixing screw B
12. Upper pillar
11. Fixing screw A
10. Power cord
8. Oscillation knob
6. Motor shaft
5. Rear grille
4. Guard knob
3. Fan blade
2. Blade locking
cap
1. Front grille
17. Safety screw
17. Pole xing nut
Rotary switch
6

Assembly
1. Remove the pole xing nut (16) from the main pillar (14) and insert the main pillar
(14) into the base (15) then tighten the xing nut (16).
2. Release xing screw B (13) and adjust height to a suitable length. Re-tighten the
xing screw B once ready.
3. Release the xing screw A (11), connect the motor housing with the upper pillar
(12), fasten it with the xing screw A (11).
4. Remove the blade locking cap (2) and the guard knob (4) from the motor shaft
(6), secure the rear guard (5) on the motor housing (9) to line up with the three
xing pins, fasten the guard with the guard knob (4).
5. Put the blade (3) on the motor shaft (6) and tighten with the blade locking cap
(2).
6. Attach the front guard (1) to the rear guard (5), and close the guard xing clips,
nally fastening with the safety screw (17)
1. Connect the plug to a power supply and switch on the power.
2. Switch the fan ON by rotating the speed control knob (7) at the rear in clockwise
direction.
3. The switch is also used to adjust the fan SPEED.
4. The airow direction can be adjusted upward/downward by lifting up or pressing
down the motor housing.
NOTE: Only adjust the fan head when the unit is OFF. Be careful not to insert your
ngers through the guard.
5. Push the oscillating knob (8) down to start OSCILLATION. Pull the oscillation
knob up to stop OSCILLATION.
6. Turn speed control knob (7) to adjust the fan speed from LOW ”1” – MEDIUM ”2”
- HIGH ”3” in sequence. Turn the switch anti-clockwise to the “0” position to turn
OFF.
7. Turn the switch anti-clockwise to the “0” position to turn the fan OFF. Speed
Operation
7

Cleaning
Over time, dust can accumulate on the front & rear grille cover and fan blades, which
can aect the fans performance. It is recommended to clean the fan at least once a
month.
1. Turn the unit OFF and disconnect the appliance from the power supply.
2. Remove any dust build up with a soft brush.
3. Wipe the surface of the unit with a soft damp cloth. Mild detergent can be used
for any stubborn marks.
Do not use abrasive sponges, scouring pads, or a sti brush to clean the
IMPORTANT
The control panel and other parts must not come into contact with water or any
other liquids.
Storage
If not using the unit for an extended period of time. After cleaning please:
• Turn the unit o, unplug and take care of the mains lead & plug.
•
Cover the unit and store it upright in a location where it will not receive direct sunlight.
NB- Prolonged exposure to direct sunlight will discolour the enclosure.
8

If the unit fails to operate eciently, is broken or other problems arise, unplug and
do not operate. Ask for advice by calling your local after sales service agent or the
Customer Care Centre on 1300 556 816 (AU) / 0800 666 2824 (NZ).
Maintenance
Recycling: Do not dispose of electrical appliances as unsorted
municipal waste. Use separate collection facilities. Contact your
local government for information regarding the collection systems
available. If electrical appliances are disposed of in landlls or dumps,
hazardous substances can leak into the ground water, polluting the
food chain and damaging health and well-being.
Warranty
Please refer to the warranty card in the box for warranty information. For any
troubleshooting advice, please contact the relative Customer Care Centre below.
Glen Dimplex Australia Pty Ltd Glen Dimplex New Zealand Ltd
1340 Ferntree Gully Road, 38 Harris Road, East Tamaki,
Scoresby 3179, Victoria Auckland 2013
Australia New Zealand
Ph: 1300 556 816 Ph: 0800 666 2824
9

Customer Care: 1300 556 816
[e-mail]
www.dimplex.com.au
Supplied by Glen Dimplex Australia
1340 Ferntree Gully Road, Scoresby, Victoria, 3179
© Glen Dimplex Australia. All rights reserved. Material contained in this publication may not be reproduced in whole or in part, without
prior permission in writing of Glen Dimplex Australia.
10