Dimplex BFRC-KIT User manual

7206620100R07
IMPORTANT SAFETY INFORMATION: Always read this manual rst
before attempting to install. For your safety, always comply with all
warnings and safety instructions contained in this manual to prevent
personal injury or property damage.
To view the full line of Dimplex products, please visit
www.dimplex.com
Installation Guide
Optional Remote
Control
Model Numbers:
BFRC-KIT
BFRC-KIT-OP

2www.dimplex.com
Table of Contents
Always use a qualied technician
or service agency to repair
this replace.
Welcome & Congratulations . . . . . . . . . . . . . . 3
IMPORTANT INSTRUCTIONS ..............4
Remote Kit Installation ...................5
Installation Set Up .....................5
Install Remote Control Receiver ..........6
Remote Control Initialization/Reprogramming . . . . .7
Operation...............................7
Remote Control Usage .................8
Maintenance ...........................9
Battery Replacement ...................9
Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
!NOTE: Procedures and
techniques that are
considered important
enough to emphasize.
CAUTION: Procedures and
techniques which, if not
carefully followed, will result
in damage to the equipment.
WARNING: Procedures
and techniques which, if not
carefully followed, will expose
the user to the risk of re,
serious injury, or death.

3
Welcome & Congratulations
Thank you and congratulations for choosing to purchase an electric
replace from Dimplex, the world leader in electric replaces.
Please carefully read and save these instructions.
CAUTION: Read all instructions and warnings carefully before
starting installation. Failure to follow these instructions may result in a
possible electric shock, re hazard and will void the warranty.
NO NEED TO RETURN TO THE STORE
Questions with operation or assembly? Require Parts Information?
Product Under Manufacturer’s Warranty?
Contact us at: www.dimplex.com/customer_support
For Troubleshooting and Technical Support
OR Toll-Free 1-888-DIMPLEX (1-888-346-7539)
Monday to Friday 8:00 a.m. to 4:30 p.m. EST

IMPORTANT INSTRUCTIONS
①Read all instructions before
using this appliance.
②Any repairs to this appliance
should be carried out by a
qualied service person.
③Under no circumstances
should this appliance be modied.
Parts having to be removed for
servicing must be replaced prior
to operating this replace again.
SAVE THESE INSTRUCTIONS
4www.dimplex.com
④Do not use outdoors.
⑤Use this appliance only as
described in this manual. Any
other use not recommended by
the manufacturer may cause re,
electric shock or injury to persons.

Installation Set Up
Open steel curtain (remove1.
glass doors if applicable).
Remove two screws on log2.
grate and remove log grate.
(FIGURE 1)
Pull front edge of plastic ember3.
bed grate up and forward until
rear tab releases from the
ledge located at the bottom of
the mirror. (FIGURE 2)
!NOTE:Log set ts tightly
into rebox, some force may be
necessary to remove.
Locate and remove the two4.
screws on the removable
bracket. Remove the bracket.
(FIGURE 3)
Locate and depress the5.
mounting tabs on the plug
connector to remove the
‘dummy plug’.
(FIGURE 3)
!NOTE: Keep the ‘dummy plug
in a safe place. You will need it if
you decide to uninstall the remote
control to operate the replace
manually.
FIGURE 1
Manual Controls
FIGURE 2
FIGURE 3
Depress
Mounting
Tabs
Bracket and “Dummy Plug”
Screws
Back
Ledge
Log
Emberbed
Rear
Tab
Front
Edge
Side Section
5www.dimplex.com
Remote Kit Installation
Removable
Bracket

6
Install Remote Control Receiver
Locate and insert the plug1.
connector on the remote
control bracket into plug
connector on the replace.
(FIGURE 4)
Place antenna under remote2.
bracket.
Locate and install the two3.
screws on the remote control
bracket.
Replace the log by inserting4.
front edge and pushing the
back down until rear tab snaps
under back ledge (FIGURE 2)
and the logs are resting against
mirror.
5. Replace log grate using two
screws previously removed.
FIGURE 4
Remote Control Receiver
Plug
Connector
Remote Kit Installation
FIGURE 5
Manual Controls & Indicator Lights

(Figure 6-A) for ve (5)
seconds. The Level 1
Indicator Light (Figure 6-D)
will then ash for 10 seconds.
Within7. the 10 seconds
press the ON button located
on the remote control
transmitter. (Figure 7) This
will synchronize the remote
control transmitter and
receiver.
Figure 6 AB C
DE F
Remote Control
The remote control has a range
of approximately 50ft. (15.25m). It
does not have to be pointed at the
replace and can pass through
most obstacles (including walls).
It is supplied with one of 2, 187
independent frequencies, in the
factory, to prevent interference
with other units.
Remote Control Initialization/
Reprogramming
Follow these steps for remote
control initialization and if
required, re-initialization:
Ensure that power is supplied1.
through main service panel.
Access the manual controls,2.
(remove the glass doors if
applicable) pull the right hand
steel curtain to the outside of
the unit. (FIGURE 5)
Locate manual controls.3.
Move the 3-way switch to4.
“Remote”.
Activate the main power5.
switch, the red Level 1
Indicator Light will ash .
(Figure 6-D)
Press and hold the On button6.
on the manual controls
7www.dimplex.com
Operation

Remote Control Usage
The remote control operation can
be adjusted, depending on the
season and desired effects, by
toggling the main mode selector
switch built into the replace.
The position of the switch will
dictate the available functions that
the remote transmitter will cycle
through.
A. On Button
Pressing this button toggles
sequentially through the three
levels of the replace.
Mode Selector Set at “O”:•
Only Flame Effect at all 3
levels.
Mode Selector Set at “--”:•
Pressing once activates Level
1 - ame effect only, two and
three times activates Level 2 -
ame effect and Purire™.
Mode Selector Set at “=”:•
Pressing once activates Level
1 - ame effect only, twice
activates Level 2 - ame
effect and Purire™, three
times activates Level 3 -
ame effect, Purire™ and
heat.
B. Off Button
Pressing this button at any time
will shut the unit off.
C. Manual Selection Switch
Switches the operation of the
replace between the different
modes of the replace:
OFF (center): Makes the unit•
inoperable.
MANUAL (top): All functions•
of the replace are controlled
by the On and Off buttons as
described above (A, B).
REMOTE (bottom): All•
functions of the replace are
controlled by the Remote
Control.
D. LED Indicators
Depicts which of the three (3)
levels the replace is currently
operating at: Level 1 - , Level
2 - or Level 3 - .
Operation
8
ON
Button
OFF
Button
Battery
Battery
Cover
Figure 7
Remote Control Transmitter

9www.dimplex.com
Maintenance
Battery Replacement
(Figure 7)
To replace the battery:
Slide battery cover open on•
the hand held transmitter.
Correctly install one (1) 12•
Volt (A23) battery in the bat-
tery holder.
Close the battery cover.•
Warranty
All Dimplex accessories are warrant-
ed against defects in workmanship
and materials for two years from date
of sale. This warranty does not apply
to damage from accident, misuse, or
alteration, nor where the connected
voltage is more that 5 % above the
nameplate voltage, nor to equip-
ment improperly installed or wired or
maintained in violation of the instruc-
tion sheet. This limited warranty ap-
plies only to purchases made in any
province of Canada except for Yukon
Territory, Nunavut, or Northwest Terri-
tories or in any of the 50 States of the
USA (and the District of Columbia)
except for Hawaii and Alaska. This
limited warranty applies to the original
purchaser of the product only and is
not transferable. No other written or
oral warranty applies. No employee,
agent, dealer or other person is
authorized to give any warranties on
behalf of Dimplex. The customer shall
be responsible for all costs incurred
in the removal or reinstallation and
shipping of the product for repairs.
Within the limitations of this warranty,
inoperative units shall be returned
to the nearest Dimplex authorized
service center, and we shall repair or
replace, at our option, at no charge
to you with return freight paid be
Dimplex. It is agreed that such repair
or replacement is the exclusive rem-
edy available from Dimplex and that
DIMPLEX IS NOT RESPONSIBLE
FOR DAMAGES OF ANY KIND,
INCLUDING INCIDENTAL AND
CONSEQUENTIAL DAMAGE. Some
States do not allow the exclusion or
limitation of consequential damages,
so the above exclusion or limitation
may not apply to you. This warranty
gives you specic legal rights and you
may also have other rights which vary
from state to state.

© 2011 Dimplex North America Limited
Dimplex North America Limited
1367 Industrial Road
Cambridge ON
Canada N1R 7G8