Dimplex ECR15 User manual

Installation and Operating Instructions
be made by children without supervision. Children
of less than 3 years should be kept away unless
continuously supervised.
Children aged from 3 years and less than 8 years
shall only switch on/off the appliance provided
that it has been placed or installed in its intended
normal operating position and they have been
given supervision or instruction concerning the
use of the appliance in a safe way and understand
the hazards involved. Children aged from 3 years
and less than 8 years shall not plug in, regulate and
clean the appliance or perform user maintenance.
CAUTION: Some parts of this product can become
very hot and cause burns. Particular attention has
to be given where children and vulnerable people
are present.
This radiator complies with stringent safety
standards but to ensure efficient operation
SURFACES OF THE RADIATOR WILL BECOME
HOT AND CONTACT WITH THESE AREAS SHOULD
BE AVOIDED, particularly between the fins.
The control panel area is designed to be cooler and
allow safe operation of the controls at all times.
IMPORTANT: The feet supplied with the appliance
must be used.
DO NOT use this heater if it has been dropped.
DO NOT use if there are visible signs of damage to
the heater.
Use this heater on a horizontal, at and stable
surface.
WARNING: Servicing and product repairs should
only be undertaken by the manufacturers approved
service agent. Repairs should only be made by
the manufacturer or his service agent.
WARNING: To reduce risk of fire, keep textiles,
curtains, or any other flammable material a
minimum distance of 1 m from the appliance.
WARNING: Risk of fire – Do not use this appliance
connected through an extension lead or any
external switching device such as a plug in timer
or remote control plug in adaptor. All heating
appliances draw high current through the mains
supply and any weakness in the design, connections
or components in these devices can easily result in
overheating of the connection points resulting in
melting, distortion and even the risk of fire!
DO NOT use the heater on deep pile carpets or
the long hair type of rugs, or less than 750mm
(30”) away from any overhanging surface. Keep
IMPORTANT: THESE INSTRUCTIONS SHOULD BE READ CAREFULLY BEFORE USE AND RETAINED FOR FUTURE REFERENCE
IMPORTANT SAFETY ADVICE
WARNING: To avoid danger of suffocation please
remove all packaging materials particularly plastic
and EPS and keep these away from vulnerable
people, children and babies.
WARNING: To avoid the risk of accidental
strangulation from the supply cord all children and
vulnerable people must be supervised when in the
vicinity of the product whether it is working or not.
DO NOT use the heater in the immediate
surroundings of a bath, a shower or a swimming
pool.
DO NOT place the heater directly below a
fixed socket outlet. The socket-outlet must be
accessible at all times to enable the mains plug to
be disconnected as quickly as possible.
WARNING: In order to avoid overheating, do not
cover the heater.
The heater carries a warning symbol to
alert the user to the risk of fire that exists
if the heater is accidentally covered.
DO NOT obstruct the air circulation around the
radiator, for example with curtains or furniture, as
this could cause overheating and a fire risk. See
‘Positioning the Radiator’.
DO NOT COVER or obstruct the air inlet and
outlet openings in any way.
WARNING: DO NOT use this heater in small rooms
when they are occupied by persons not capable
of leaving the room on their own, unless constant
supervision is provided.
IMPORTANT: If the mains lead of this appliance is
damaged, it must be replaced by the manufacturer
or its service agent or a similarly qualified person in
order to avoid a hazard.
WARNING: In order to avoid a hazard due to
inadvertent resetting of the thermal cut-out, this
appliance must not be supplied through an external
switching device, such as a timer, or connected to
a circuit that is regularly switched on and off by
the utility.
This appliance can be used by children aged from
8 years and above and persons with reduced
physical, sensory or mental capabilities or lack of
experience or knowledge if they have been given
supervision or instruction concerning the use of
the appliance in a safe way and understand the
hazards involved. Children shall not play with the
appliance. Cleaning and user maintenance shall not
As with all portable heating appliances: This product is suitable only for well insulated spaces or occasional use.

ELECTRICAL CONNECTION
WARNING THIS APPLIANCE MUST BE EARTHED
DO NOT use an extension lead or multi-plug adaptor when
connecting this product to the mains. Connection through these
devices could lead to risk of overloading, overheating and even fire at
the extension lead or adaptor due to inadequate connection quality.
This heater must be used on an AC (~) supply only and the voltage
marked on the heater must correspond to the supply voltage. This
heater is fitted with a plug incorporating a 10 amp fuse. When
replacing the fuse, a 10 amp fuse approved by ASTA to BS 1362
must be used.
If the plug is damaged or not suitable for your socket outlets in your
home, the plug must be cut off and an appropriate one fitted. A plug
cut off from a mains lead will give a shock hazard if inserted into
a 13 amp socket elsewhere in the house. To avoid this, it should be
disposed of immedaitely.
NOTE: The fuse cover of a non-rewirable plug must be fitted when
changing the fuse. Should the cover bocome lost, the plug must be
replaced.
IMPORTANT: The wires in this mains lead are coloured in accordance
with the following code:
GREEN AND YELLOW: EARTH
BLUE: NEUTRAL
BROWN: LIVE
As the colours of the wires in the mains lead may not
correspond with the coloured markings in your plug,
proceed as follows:
Connect the BROWN wire to the terminal marked ‘L’ or
coloured RED. Connect the BLUE wire to the terminal
marked ‘N’ or coloured BLACK. Note: ‘L’ or ‘N’ must not
be connected to the EARTH terminal marked ‘E’ or ‘’ or
coloured GREEN or GREEN AND YELLOW.
If in doubt, consult your electrician.
Assembly and Positioning
FITTING THE CASTORS
WARNING The radiator must only be operated
with the wheels and castors fitted and in the
upright position.
The castors must be fitted to the control panel and on
the bracket between the last and second last fin on the
opposite end, as shown in Fig.1.
To fit the castors, turn the radiator upside down on a
carpet or other soft surface to avoid damage
WARNING : THE RADIATOR IS HEAVY – ENSURE THAT
IT IS SUPPORTED TO PREVENT IT FROM TOPPLING. Ask
a second person to help with this if necessary.
To fit the castors, position the castor plates (A) in position
and secure using the wing bolts (B). there are guides
to ensure the correct positioning and orientation of the
caster plate.
Return the radiator to the correct orientation so it rests
on the castors. The product is now ready for use.
A
B
Fig. 1
POSITIONING THE HEATER
Select the position for the heater ensuring there is clearance
from any furniture and fittin gs of at least 300mm above the
heater and 150mm each side and 300mm from the control and
end panel. We recommend maximising the clearance where
possible.
Models & General Information
Model Description Power
(W)
ECR20Ti(B) 9 fin, thermostat, three heat settings, neon
& electro mechanical timer 2000
GENERAL
The radiator is designed for operation on an AC electricity
supply, and is suitable for use in domestic dwellings and similar
indoor locations.
The radiator is fitted with castors and a handle for ease of
movement. A rotary selector switch provide the ability to
choose an available heat output and an adjustable thermostat
enables the room temperature to be controlled accordingly. It
is supplied with a cord and plug and is ready for use once the
castors have been correctly fitted.
Thermostat
Off/Heat selection swit
ch
Neon Indicator
Timer - Ti(e) models
Cable Wrap
Fig. 2
combustible materials such as drapes and other
furnishings clear from the front, sides and rear of
the heater. Do not use heater to dry your laundry.
DO ENSURE that the mains lead cannot be tripped
over.
DO NOT operate the radiator with the mains lead
overhanging the fins.
If the radiator is tipped over, unplug it and allow it
to cool before standing it back up.
DO NOT pull, carry or move the appliance using the
power cable.
The supply cord should be uncoiled before use.
This instruction leaflet belongs to the appliance and
must be kept in a safe place. If changing owners,
the leaflet must be surrendered to the new owner.

This appliance incorporates a number of safety devices. In
addition to the ‘Important Safety Advice’ section your attention
is drawn to the following;
Tilt Switch
The tilt switch will prevent the heater from working if it is
accidentally tipped over on its side.
If the radiator is tipped over while it is hot, disconnect the
power and allow it to cool, then stand the radiator back upright.
Reconnect the power - normal operation should be resumed.
Safety Overheat Protection
The heater is fitted with a temperature limiter which will reduce
the output of the heater should it overheat for any reason. The
product will return to normal operation after the cause of the
over heating has been rectified.
Safety Features Additional
Storage
If the radiator is not required for long periods, for example
during the summer, it should be stored in a dry place and
preferably covered to prevent the accumulation of dirt and
dust. The supply cord should be neatly coiled around the cable
wrap, see Fig. 2
IMPORTANT
The heater must be kept plugged in at the mains to retain the
time and the programmed settings. If unplugged from the
mains, resetting the time and the programmed settings will be
necessary.
Cleaning
WARNING - ALWAYS DISCONNECT THE POWER SUPPLY
BEFORE CLEANING THE HEATER.
Do not use detergents, abrasive cleaning powder or polish of
any kind on the body of the heater.
Allow the heater to cool, then wipe with a dry cloth to remove
dust and a damp cloth (not wet) to clean off stains. Be careful
not to allow moisture in to the heater.
Model Identifier(s): ECR12(Ti(e)) ECR15(Ti(e)) ECR20(Ti(e)) ECR25(Ti(e))
Heat output
Nominal heat output Pnom 1.2 1.5 2.0 2.5 kW
Minimum heat output (indicative) Pmin 0.4 0.5 0.6 0.8 kW
Maximum continuous heat output Pmax,c 1.2 1.5 2.0 2.5 kW
Auxiliary electricity Consumption
At nominal heat output elmax 0.0 0.0 0.0 0.0 kW
At minimum heat output elmin 0.0 0.0 0.0 0.0 kW
In standby mode elSB 0.0 0.0 0.00.0 kW
Type of heat output/ room temperature control
With mechanical thermostat room temperature control Yes
Contact details UK: Glen Dimplex UK Ltd., Millbrook House, Grange Drive, Hedge End,
Southampton SO30 2DF
ROI: Glen Dimplex Europe Limited, Airport Road, Cloghran, County Dublin,
K67 VE08
Spares
The castor set (2 pairs) for OCR20TiB/ECR20TiB- part number X-6019010
Switch setting
Model O I II III
ECR15(Ti(e)) Off 500W 1000W 1500W
ECR20(Ti(e)) Off 600W 1400W 2000W
Model Description Power
(W)
ECR15 7 fin, thermostat, three heat settings & Neon 1500
ECR15Ti 7 fin, thermostat, three heat settings, neon & electro mechanical timer 1500
ECR20 9 fin, thermostat, three heat settings & Neon 2000
ECR20Ti(B) 9 fin, thermostat, three heat settings, neon & electro mechanical timer 2000
ECR20Tie 9 fin column, thermostat, three heat settings, neon & electronic timer 2000

.
Guarantee
[c] Glen Dimplex
All rights reserved. Material contained in this publication may not be reproduced in whole or in part, without prior permission in writing of Glen Dimplex.
These products comply with all the required European Product Safety, Electromagnetic Compatibility and Environmental Standards.
They are fully compliant with the LVD, EMC, RoHS and Eco Design Directives.
08/54315/0 Issue 7
www.dimplex.co.uk
Glen Dimplex Heating and Ventilation
Millbrook House, Grange Drive, Hedge End, Southampton, SO30 2DF
Glen Dimplex Europe, Airport Road, Cloghran, Co. Dublin K67 VE08
Your Product is manufactured by Glen Dimplex UK operating as Glen Dimplex Heating & Ventilation. GDHV designs and
manufactures products to ensure they deliver reliable service for normal use in domestic dwellings and, where specified by
us, in light commercial premises.
Your product is under guarantee for 1 year from the date of purchase or the date of delivery of the product, if later. The 1 year
guarantee is extended for an additional 2 years when you register the product with Dimplex, within 28 days of purchase. If
you do not register the product with Dimplex within 28 days, your product will remain guarranteed for 1 year only. To validate
your extended guarantee register with us online at: https://www.dimplex.co.uk/register.
Your guarantee is provided by Glen Dimplex UK Ltd operating as Glen Dimplex Heating & Ventilation Ltd, Millbrook House,
Grange Drive, Southampton SO30 2DF. Terms and conditions apply.
The GDHV guarantee does not in any way diminish or affect your statutory consumer rights in connection with your product.
If you experience a problem with your product during or after the guarantee period, visit our online help
centre:
support.dimplex.co.uk
Please note for support you will need the model and serial number of your product and a description
of the fault which has occurred.
To view the full guarantee terms and conditions scan this QR code using your smartphone or go to
https://www.gdhv.co.uk/guarantee-terms-and-conditions.
Important: For electrical products sold within the European Community. At the end of the electrical products
useful life it should not be disposed of with household waste. Please recycle where facilities exist. Check with
a Local Authority or retailer for recycling advice in your country. Batteries should be disposed of or recycled in
accordance with WEEE Directive 2012/19/EU. Packaging should be recycled where possible. If you don't intend to
keep the packaging of this product for later use or storage, please dispose of it in an eco-friendly way, please dispose of
it in your recycling bin or nearest recycling facility, thank you.