Direct Healthcare Group GATE Bure Double 2.0 User manual

A DIRECT HEALTHCARE GROUP COMPANY
GATERD.SE
Bure Double 2.0
Technical Manual

BURE DOUBLE 2.0
GATERD.SE2

TECHNICAL MANUAL
3
GATERD.SE
The new Bure Double is equipped with twin electric drives for raising and lowering the walker and widening the
walking frame. The new version has a signicantly lower height above the walking frame for better access and
a higher user weight (150 kg) compared to the earlier version.
Contents
1. Replacement parts list 04
2. Accessories 04
3. Electrical system – Technical data 06
4. Remote Control Plus 06
5. Control box wiring 07
6. Battery charging 07
7. LED on controlbox and battery 07
8. Maintenance 08
9. General safety/maintenance advice 09
10. ID label 09
11. Recycling/Scrapping 09
12. Warranty 09
13. Technical specications 10
Bure Double 2.0

BURE DOUBLE 2.0
GATERD.SE4
1. Detaljförteckning reservdelar
157-306
57-305
Armrestpad left
Armrestpad right
12 58-364 Circular plate
258-365 Frame/Armrest 13 58-352 Cross section
357-041-3 Holder, Remote control (TH7) 14 58-302 Bearing (x2) Cross section
457-369
57-370
Clamp/Battery (alu)
Plate Clamp/Battery (alu)
15 58-353 Turn axle, beam
558-376 Battery, TiMotion 16 57-776
57-775
Cover, Wheel
Washer, wheel
658-377 Actuator, TiMotion 17 58-360 Cover, Wheelplate (PA)
758-373
58-373-1
Controlbox 220V, TiMotion
Controlbox 110V, TiMotion
18 58-354 Wheel mount beam
858-366
58-335
Vertical frame
Telescopic Innertube
incl. Bronzebearing
19 57-051
57-319
57-049
Wheel 75mm
Wheel 100mm
Wheel 125mm
958-358 Sideplate (2x) alu 20 58-379-L
58-379-R
Bottom beam, left
Bottom beam, right
10 58-356 Aluprole, widening 21 Linking arm, right
11 58-378 Actuator, widening 22 Linking arm, left
2. Tillbehör
Art. Nr. Benämning
Manual brake, 2handles
Manual brake, 1handle
56-333-DB Standing plate, Short
56-383-DB Standing plate, Long
56-334 Dripstand, Chromed
56-335 Holder for Dripstand
56-336 Oxygen tubeholder
56-337 Side support
56-338 Dripstand holder, Complete
56-387 Wheel w brake 75 mm
56-358 Wheel w brake 100 mm
56-361 Wheel w brake 125 mm
57-361-L Armrestpad PUR left
57-361-R Armrestpad PUR right
58-374-2 Remote Control (TH7)
56-062 Remote Control PLUS, DB (TH10)
58-320 (-1, -2, -3) Cable/EUR (-UK, -US, -AUS)
58-326 (-1, -2, -3 Coiled Cable/EUR (-UK, -US, -AUS)

TECHNICAL MANUAL
5
GATERD.SE

BURE DOUBLE 2.0
GATERD.SE6
3. Elsystem - Tekniska Data
Actuator Lift Widening
Producer T-Motion T-Motion
Voltage 24V 24V
Push 2000N 1000N
Pull 2000N 1000N
Self-locking push 1000N 1000N
Current 4.6A 2.8A
Colour Svart/Black Svart/Black
Stroke 400mm 55mm
Mounting dim 605mm 167mm
Encapsulation IP66 IP66
IEC60601-1 3rd revision
Controlbox + Battery
Producer T-Motion
Voltage 24V
Capacity 2.0AH
Encapsulation IP66
Colour Svart
Electrical safety Class II (Dubbelisolering/Doubleinsulation)
IEC60601-1 3rd revision
4. Remote Control Plus
**1. Service indicator – ashes red after 11 months’ operation.
Constant light (red) after 12 months’ operation. The indicator is a reminder to review the maintenance
instruction (see Instructions for Use/Technical Manual. This should be done at least once every 12 months.
Reset: hold down buttons <2a> + <2b> for at least 30 seconds.
**The indicator will go out around 30 seconds after the remote control is
activated (battery conservation function).
1
2a 2b

TECHNICAL MANUAL
7
GATERD.SE
5. Control box wiring
Remove the control box cover to make the connections as described below.
Use a screwdriver or similar; refer to the special labels on the control box.
NOTE: Make sure that plugs are connected to the correct sockets otherwise the
actuators can be damaged.
1. Socket for the height adjustment actuator.
2. Socket for the width adjustment actuator.
3. Remote control socket.
4. Battery terminal socket.
5. Plug socket (NOTE: Plugs must ALWAYS be connected to the control box
for IP classication to be valid).
6. Battery charging
• Connect plug to 230V wall socket. Charging begins automatically and the
battery LED ashes green.
• Make sure the battery is fully charged before using for the rst time. It takes
around 25 h to fully charge the battery.
• We recommend that the battery plug be removed from the control box if the
product will be out of use for an extended period (more than one week) or if
the battery is switched off by means of the ON/OFF switch. This eliminates
the risk of disabling the battery as the control box always uses a small
quantity of electricity even when the walker is not in use.
7. LED on controlbox and battery
• Control box – green light when power is available from battery/mains
socket.
Battery:
• The LED ashes green during charging.
• ON/OFF: To use the product, press ON.
• The green lamp will begin to ash.
• Use the OFF button (hold down for 5 s) to switch off the battery if the
product will not be used for an extended period.
• The LED will shows a constant green light when the battery is fully charged.
• When the battery is in normal state/in operation, the LED ashes green at
REGULAR intervals, namely 0.5 s ON, 4 s OFF.
• When the battery requires charging (remaining charge <25%) the LED will
ash orange/red at REGULAR intervals, namely 0.5 s ON, 4 s OFF.
NOTE: The battery has an in-built device that automatically switches it off when
remaining charge is <20%. The LED is then extinguished. The battery must now
be fully charged before the electronics can be used again.
1 2
5
3
4

BURE DOUBLE 2.0
GATERD.SE8
8. Maintenance
Recommended at least once per year.
Check that Action
General
The walker feels rm/does not feel loose.
The walker does not rattle during manoeuvres.
The walker is level and all of its castors are in contact
with the oor.
The walker is not dirty.
Clean with lukewarm soap solution or alcohol-based
cleaning agent (no petroleum products).
Arm rests
Arm rests are intact and clean.
Arm rest widening is functional.
Clean; replace if damaged.
Replace lock knob.
Handle
Grips are not damaged/dirty.
Handle adjustment is functional.
Clean with lukewarm soap solution (no petroleum
products).
Replace handle grips.
Fit lock knobs/plates as required.
Battery
Check that the charging cable is connected to the
control box.
Check that the remote control is connected to the
control box.
Connect or t new remote control as required.
Check that the battery, actuators and control box
are not loose.
Fit new cable; this must always be connected to the
control box (IP65 classication).
Connect; replace with new remote control as
required.
Refer to the wiring diagram in the Technical manual.
Tighten; replace with new fasteners as required
Height/width adjustment
Raising and lowering are functional.
The walker feels stable at maximum settings.
There is no looseness between the vertical frame and
bottom frame.
Height adjustment clamps lock.
The electric actuator must not feel loose.
Height adjustment via remote control is functional.
The electric actuator must run smoothly at a constant
speed.
Fit new guide sleeves (in frame) or end plugs
(in chrome tubes) as required.
The technical manual shows the design and which
fasteners must be checked. Contact the distributor if
the parts cannot be tightened.
Replace clamps.
Tighten the attachment tting concerned; replace
bolts/lock nuts as necessary.
Check that the battery/remote control/actuator are
connected in accordance with the wiring diagram.
Charge the battery. Contact customer services.
Frame parts
There is no mechanical damage.
There are no scratches.
End plugs/lower frame tted.
If damage is present, contact GATE’s customer
services.T ouch up as necessary.
Fit new end plugs.
Castors/brakes
Castors roll easily/tread not damaged.
The castors are tightly fastened to the lower frame.
Castor brakes functional on all castors.
Handbrake functional.
Clean or replace castors (NOTE! Castors are
always xed to the lower frame with thread locker
or lock nuts. The castors are sealed and we do not
recommend their dismantling; instead, replace the
whole castor assembly.
Tighten the castor bolt and t locking nut or use
thread locker (depends on model). Replace castor
assembly. Adjust the brake or t new castors.

TECHNICAL MANUAL
9
GATERD.SE
9. General safety/maintenance advice
The Bure Walker may only be used:
• As a WALKING AID / STAND-UP AID
• INDOORS on HARD, LEVEL surfaces.
Before use, always check that:
• The product feels rm, secure and stable
• Harnesses, belts and attachments are intact and undamaged
Wipe the walker and its armrests clean as necessary; use soap solution/surface disinfectant. Be aware of
battery charge status (LED) – charge as necessary.
10. ID label
1. Part number
2. Product name
3. Date of manufacture
4. Max user weight
5. Serial number
6. EAN code
11. Recycling/Scrapping
When the product is no longer usable it should be recycled in accordance with legislation and regulations
in the country concerned. All electrical parts including batteries must be removed and recycled as electrical
components. (Ask your local recycling station for further information about how the different materials in the
product (metals, plastics, electronics) should be recycled).
12. Warranty
We provide two years’ warranty for manufacturing faults (does not apply to wear parts).
For further information or enquiries please contact:
Gate Rehab Development AB
Industrigatan 2, S-330 21 Reftele
tel [phone]
[email protected]
56-303
Gåbord Double 2.0
1
5
2
3
4
6
A DIRECT HEALTHCARE GROUP COMPANY

BURE DOUBLE 2.0
GATERD.SE10
13. Technical specications
Dimensions apply to walkers with 125 mm castors.
Part no. Product width Max user
weight
Length Height Weight Armrest/Internal
dimension
56-303 64-95cm 150kg 87cm 90-130cm 40kg 25-50cm

TECHNICAL MANUAL
11
GATERD.SE

GATERD.SE
Gate Rehab Development AB
Industrigatan 2
Reftele, Sverige
S-330 21
T: 0371-318 00
F: 0371-318 01
E: [email protected]
LIT-00095 Issue 1
Date: January 2020
A DIRECT HEALTHCARE GROUP COMPANY