Rebotec Polo Standard User manual

75
Operator’s Manual: Rollator
Polo Standard
Art. No. 180.00
Polo Plus
Art. No. 181.00
REBOTEC Rehabilitationsmittel GmbH
Zoppoterweg 1
D-49610 Quakenbrück,
Telephone: [phone]
Telefax: (+49) 5431/9416-66
http://www.rebotec.de
Email: [e-mail]
Spare Parts List and Accessories
Art. No. Name Material
189.10.10 Basket for Rollator Plastic coated wire
189.00.14 Bag for basket Plastic
280.00.45 Wheel, Rollator D=200x40 for POLO-Standard Plastic
280.00.46 Wheel Rollator D=200x55 for POLO-Plus Plastic
280.10.52 Brake block Polyethylene (PE)
280.00.60 Brake lever 1.265x1.000 Niro incl. nipple VA steel
280.00.72 Front wheel left, complete for POLO-Standard Plastic, steel
280.00.73 Front wheel right, complete for POLO-Standard Plastic, steel
280.00.75 Front wheel left, complete for POLO-Plus Plastic, steel
280.00.76 Front wheel right, complete for POLO-Plus Plastic, steel
280.10.48 Upholstery for back frame PUR
Warranty
We provide a 24-month warranty for all our Rollators - all parts subject to wear are excluded.
Re-Use (Rental)
Please refer to the more strict conditions of the German Product Liability Act (ProdHaftG§1, Part 2, No.1)
Serial No.:
11/2004 (UW)
Use
The Rollators are designed for people with limited walking ability, and to increase their confidence when
walking.
Please allow your specialised dealer or care provider to advise you on using the Rollator, and on its
proper adjustment for function
CE
REBOTEC
Declaration of Conformity
We declare with sole responsibility that this product:
Name: Rollator
Version: 180.00 POLO – Standard
181.00 POLO - Plus
fulfils the general requirements as to the EUDirective 93/42
EWG.
Quakenbrück, November 29, 2004 U. Westphal____
(Safety Appointee)

AssemblyInstructions and First-Time Use
1. Unfold Rollator.
Place the Rollator on its front wheels and push apart the frame (A) together with the back wheels.
The Rollator will click into its final position (B) byitself. Lower the seat into the table position (M)
2. Adjusting the handles.
Next remove both star-grip hand-screws (C). Select the appropriate height (D) and set the
handles at the next screw hole. Put back both star-grip hand-screws (C) and tighten them
securely.
3. Hang the basket.
First flip up the tablet / seat (F) and place the basket (E) in the frame. Return the table / seat (F)
back to its original position.
4. Using the brakes.
By pulling up the right and left brake levers (G), the rear wheels are braked at their respective
sides. The permanent brake is activated by pushing down the brake lever (H). By pulling it back
up (G) the brake is returned to its neutral setting.
5. Folding up the Rollator.
If in place, first remove the basket (E). Next pull up with one hand the bracket (J) for clicking into
position and, using the other hand, lift the Rollator at the frame below the tablet / seat (F).
6. Using the seat
Fold back the seat to position (N).
Before using the seat, set the permanent brakes (H).
Warning! When the sun is shining, it is possible that the seat will get hot.
When using the seat, its temperature should not be more than the temperature of your hand.
7. Adjusting the brakes
First loosen the counter nut (L) and then adjust the brake with the adjusting screw (K).
Please be sure, when the brakes are released, that the wheels are able to turn freely. And when
the brake levers are pulled, the wheels are securelybraked. To complete the adjustment, tighten
the counter nut (L).
Inspection and SafetyAdvisories
After setting up the first time, and before each use, a visual inspection for deficiencies must be
performed (in the event of any doubt - do not use the equipment!). Also an inspection of all
screwed connections must be done (if necessary tighten screw connections with the proper
tools).
Before using, check over the folding mechanism to be sure it locks in its unfolded end-position.
Before using, check over the brakes and the permanent brake for function.
Do not load the basket with more than 4 kg. when using the Rollator – Danger of tipping over –
and never use the tablet position (M) as a seat. – Danger of tipping over! (See section 6).
Technical Specifications
Weight Polo-Standard w/o basket : 6.9 kg
Weight Polo-Plus w/o basket : 7.2 kg
Weight, basket for Rollator : 0.4 kg
Max. body weight : 120.0 kg
Max. basket load : 4.0 kg
Depth : 700 mm
Width : 620 mm
Adjustable handle height : 800 mm – 980mm, 10 positions
Seat height : 620 mm
Seat width : 425 mm
Maintenance
The surface of the aluminium tubular frame is covered with a long-lasting, durable powder paint
coating. The Rollator maybe easilycleaned using commercially available cleansers and
disinfectants.
All moving parts are permanently lubricated and are maintenance-free.
B
H
G
L
K
E
A
C
J
D
FM N
Warning!
Load the basket
with max. 4 kg !