DirecTV SWM8 User manual

SWM-8
07/07
DIRECTV Inc.
2230 East Imperial Highway
El Segundo
California
8 CH SWM Install Quick Reference Guide
Note: some equipment may be marked "FTM" instead of "SWM"
DIRECTV approved
splitter
Terminate PI IRD port
if not used to connect IRD
SWM to PI + PI to IRD =
200 ft max. RG6 cable
with or without a splitter
SWM DVR IRDs
< 40 ft
"autodetect" not supported,
manually select
dish configuration
Terminate SWM Port 2 if not used
Power Inserter
(Indoor use only)
Do NOT use BBC's
* Same flexport rules as 6 x 8 multiswitch.
When the 72.5W satellite isn't required,
the 95W satellite antenna should be
connected to the Flex Port # 1.
Flex Port # 2 isn't used.
KaKu 95* 72.5*
OFF-AIR (for MDU)
DVRs use 2 channels each
Non DVRs use 1 channel each
Perform a Red button reset after connecting signal to IRD in order for it to configure to the new settings.
Do
Not
use "autodetect", manually select dish configuration
IEC
®
DR
CAUTION
IRD SAT port "F" Connector Shall Never be
Connected to PI's SWM port (Red Connector).
Doing So Will Damage the IRD