Discount Car Stereo PXDXFD4 Instruction Manual

Courtesy of:DiscountCarStereo.com
PXDXFD4
Quick Start Installation Guide for 2000-04 Ford 12-pin Radios
Revised March 27, 2019

Introduction:
Many Ford and Jaguar Owners looking for a simple and effective way of
connecting their portable audio devices to the car system will be pleased to find
this kit. The PXDXFD4 Kit works on 1999-04 Focus/Cougar & 2000-02 Jaguar
S-type and the only requirement is to disconnect the factory external CD
Changer**, but with the storage capacity of most portable devices, sacrificing
the CD Changer should be an easy decision.
Installation:
Remove radio from dashboard to gain access to the connectors. Special
removal tools are required. (Not included) (See Fig. 1)
Fig. 1
Radio Removal Tool
1. To remove Ford radio simply push tools into keyholes on both sides of
radio until locked, then (1) push tools slightly sideways and (2) pull
forward as illustrated in Fig. 2
Fig. 2
2. Look for green 12-pin connector as seen in Fig.2
Fig. 2
12-pin Radio Connectors
3. If present- disconnect factory 12-pin plug from radio and connect black
12-pin plug from installation harness (See Fig. 3)
Fig. 3
Installation harness

4. Connect 22-pin Molex plug from installation harness (See Fig. 3) to the
22-pin connector on Module (See Fig. 4)
Fig. 4
22-piin Molex connector
5. Turn dip switches # 2 & # 8 to “ON” or down. All others should be “OFF”
or Up (See Fig. 5)
Fig. 5
dip-switches
6. Connect one of two audio cables included to 8-pin input on Module.
(See Fig. 6)
Fig. 6
8-pin DIN input
7. Route 3.5mm plug to front of the dash or location where audio device will
reside (within 6 ft.) or connect and route a set of audio cables (not included)
to audio device
Test Operation:
1. Turn Radio “ON”
2. Press “CD”button on radio to enter CD Changer Mode
3. Connect audio device to 3.5mm plug on 6 ft. Audio cable (See Fig. 6) or
to RCA jacks.
Fig. 6
3.5mm plug
4. Search audio device for a test rack and hit play. Music from Audio
device will play on car speakers.
5. Use radio volume control button to set the playback level. To reduce
distortion we recommended setting audio device volume level to 80%
or less
Warning! Playlist and Track selection is *NOT* possible from the radio.
You must use the audio devices built-in controls to access audio files.
6. If correct operation is confirmed go ahead and reinstall the Radio.

Frequent asked questions
1. Does the PXDXFD4 work on other Focus Radios?
NO;Focus with Blaupunkt CD/MP3 Player requires our PXDXFB.
2. Can I use the radio buttons to control the audio device
NO; Auxiliary input adapters are passive devices that do not control the audio
device. Use audio device built-in controls to access music files. Use radio volume
control button to set playback level.
3. Can I charge my iPod or iPhone from this module?
NO; this module is for audio playback only, however with optional PODCBLB-5V
dock cable, users can play and charge (no controls) Apple 30-pin iPod and iPhones
or as an alternate purchase our PXDP Kit
4. Does this Kit work on other Jaguar Radios
NO; The PXDXFD4 works only on 2000-02 S-Type Radios with “CD” Changer
controls
** External or remote CD Changer refers to the optional Changer installed on the lower dash,
center armrest, hatch, trunk etc. (external CD Changer is not the Changer built-into the head
unit)
Email [e-mail]
©1995-Mar-19 Discount Car Stereo, Inc. All rights reserved. Information in this document is
subject to change without notice. Other products and companies referred to herein are
trademarks or registered trademarks of their respective companies or mark holders.