Displays2go DCRDUVPRNT User manual

1. Take the 2 hook side panel and insert into center
panel as shown in images below. Make sure LED light
indent is on top.
2. Take 3 hook side panel and repeat step one.
3. Slide both side panels down so hooks lock into
place.
4. Pick the assembeled acrylic X by the center panel and
insert into base as shown in the top two images below.
Next take the top cap and insert on to top, as shown in
the two lower images.
PARTS LIST
Center Panel X1 Top Cap X1Base X1
Open all boxes first and layout all parts on a level and sturdy floor. Reference parts list to verify that all parts
and hardware are present.
Before you begin, read instructions thoroughly prior to assembly. 2 people are required for the installation.
ASSEMBLY INSTRUCTIONS
Round Display Unit- DCRDUVPRNT
Rev. 12/18 1 of 2
DCRDTOP X1 3 Hook Panel X1 2 Hook Panel X1 DCRDUVPRNT X1

5. Take Velcro side of DCRDUVPRNT and wrap
around the assembled center piece attaching it to the
Velcro on the outside of the base and top cap. See the
images below.
6.Take DCRDTOP and place inside lip formed by
DCRDUVPRNT.
If you have any questions regarding our products, please visit us at www.displays2go.com or contact D2G customer
service at 844-221-3388.
ASSEMBLY INSTRUCTIONS
Rev. 12/18 2 of 2
Round Display Unit- DCRDUVPRNT
8. Completely Assembled Unit
7. Run power cord through hole in artwork.