Displays2go FRMRCKWT66DS User manual

1. Take Screen and insert into brackets making sure
the screen hits the bottom of the brackets shown
below.
4.Remove screw A and replace with screw and
spacer provided in the kit. Repeat steps for screws
B,C, and D. Only screw half way.
PARTS LIST
Front Panel X1 Back Panel X1
Open all boxes first and layout all parts on a level and sturdy floor. Reference parts list to verify that all parts
and hardware are present.
Before you begin, read instructions thoroughly prior to assembly. 2 people are required for the installation.
ASSEMBLY INSTRUCTIONS
Rev. 19.10 1 of 2
Screws X6Spacers X4
21.5" Screen X1
5.Remove screw E and replace with a screw from kit.
Repeat step for screw F. Only screw halfway.
Zip tie X1 and Zip tie
holder X1
2. Next tie the IR cable to the zip tie holder using the
zip tie shown in the images below. Make sure it is
secured tightly.
3. Peel bottom of zip tie holder to stick to front panel
and place IR over hole like the images below.
SMABLCD - DIGITAL SCREEN MASTER SKU: FRMRCKWT66DS

7.Tighten screws B through F. Next loosen screws A and C
as shown in the second image below. Screws A and C do not
need tightening.
8.Take back panel and hook into top screws as
shown in the images below.
If you have any questions regarding our products, please visit us at www.displays2go.com or contact D2G Digital
product service # 844-221-3393 .
ASSEMBLY INSTRUCTIONS
Rev. 19.10 2 of 2
Side note: For cord management use cable hider strips
provided with unit to run along the unit. Instructions are
provided in box of strips. Best to place one strip at a
time.
9.Assembled Unit.
6.Slide front panel on the bottom screws first like
in the images below. Then push front panel
towards the top and hook into place.
SMABLCD - DIGITAL SCREEN MASTER SKU: FRMRCKWT66DS