Displays2go TSECOTSW User manual

SKU: TSECOTSWSKU: TSECOTSW
Assembly InstructionsAssembly Instructions
Standing Signage WallStanding Signage Wall

2
PARTS LIST
PART QUANTITY
A: Signage Board..................................1
B: Side Panel ..........................................2
C: Back Panel.........................................1
D. Screw 1.5in ....................................... 4
E. Screw 2in ........................................... 2
F. Wing Nut ............................................ 6
Tool recommended: Hex wrench.
If you have any questions regarding our products, please visit us at www.displays2go.com or
contact Displays2go customer service at 844-221-3388.
A
E
B
C
D
F
Scan QR code to
visit product page

3
1. Unfold the signage board and expand both ends to reach full width.
2. Attach one side panel to the end and align precut holes at the same level. Insert 1.5in screws
into top and middle holes and fix with wing nuts from the inside.
Note: Do not fix the bottom.
This step will be finished later.

4
3. Assemble the other side panel the same way as in Step 2 .
4. Fold in both side flaps on the back panel and attach it to the back of the signage board. Use 2in
screws and wing nuts to fix the back panel and stablize the whole signage wall.

5
Eny r wEny r w
tnding ia W!tnding ia W!
CONTACT INFORMATION:
www.displays2go.com
PHONE: [phone]
5. The assembly is finished. Position the signage wall at the desired angle and location.