Displays2go DGIWBS65 User manual

1
ASSEMBLY INSTRUCTIONS
To ensure your personal safety and proper use of the product, please read
this manual carefully before installation.
This product is compatible with 65-86 inch smart interactive displays.
This product can bear up to 220 lbs.

Packing List:
A- Left foot 1pcs
B- Right foot 1pcs
C - Bracket 1pcs
D - Shelf 1pcs
E - Caster 4pcs
Hardware and Tools:
M8×25
14pcs
Cross recessed hex head screw (including
positioning bolts)
M12 spring washer
4pcs
Phillips screwdriver (user-supplied)
1pcs
Adjustable wrench (user-supplied)
1pc

3
Step 1: Lock the casters in place to prevent movement during assembly, and then screw the casters to
the bottom of the feet (see Figure 1).
Lock the caster.
Figure 1

2
Step 2: Attach the bracket to one foot (see Figure 2).
1
Hole location for mountin g
bracket
C
3
4
5
①
6
Front
Front
Figure 2

5
Step 3: Attach the other foot to the bracket (see Figure 3).
Step 4: Install the shelf (see Figure 4).
Figure 4
Hang the

Step 5: Attach the two hooks to the back of the display (see Figure 5).
Step 6: Hang the hooks with display onto the bracket and tighten the security bolts on the
bottom of the hooks (see Figure 6).
Ensure the casters are locked in place. This operation shall be completed by at least
two professionals.
Figure 6

Step 7: Refer to the figure below to check if the product is installed properly.
If you have any questions regarding our products, please visit us at www.displays2go.com or
contact our customer service at 1-844-221-3393.