DITEC Bixa G4 Owner's manual

Programming Manual
http://www.remotecontrol-express.com - TEL : [phone] - FAX : [phone]
DITEC Bixa G4
Programming of your new remote control:
There are several methods for programming your new remote control.
From a remote control that has already been programmed:
1. With a sharply pointed object, press the hidden button PRG on your already-programmed
remote control for 2 seconds.
2. Press a button on your new remote control. Let it go.
3. Wait 10 seconds.
4. Your new remote control is programmed.
From the receiver :
1. Open the casing of your receiver. It is located next to your motor.
2. On the receiver circuit board, press the programming button PRG. The LED light on the
receiver illuminates and blinks. Let the button go.
3. The LED light on the receiver remains lit fixedly. Press a button on your new remote control.
Let it go.
4. Wait 10 seconds.
5. Your new remote control is programmed.

Programming Manual
http://www.remotecontrol-express.com - TEL : [phone] - FAX : [phone]
To erase all your remotes control :
1. Press the button PRG of your receiver for 3 seconds. The LED light on the receiver blinks.
2. During the following 5 seconds, press the button PRG again. The LED light blinks faster.
3. All your remotes control are erased.