DITEC GOL4 User manual

www.ChronoRemoteControl.com
Manual
DITEC: GOL4 et GOL4C
Coding of a remote controls DITEC GOL4 (white LED) et GOL4c
(red LED):
Ditec remote controls GOL4 and GOL4C are not compatible with each other:
Coding based on a remote already in use:
1) Simultaneously press buttons CH1 and CH2 of a new remote control and hold
for 5 seconds. The red LED turns on.
2) Within 10 seconds, take GOL4C or BIXLS2 (old model) remote already in use.
Hold one button and put the remote controls together as showed on the pictude
below (The front of the old remote should touch the space between the buttons
of the new one.).
3) The LED of the new remote control flashed 3 times as a sign of a successful
operation.

www.ChronoRemoteControl.com
Registration of a code on a GOL4C remote (equivalent to coding using the dip-
switches of the old BIXLS2 model):
1) Simultaneously press buttons CH1 and CH2 of a new remote control and hold
for 5 seconds. The red LED turns on.
2) Within 10 seconds, copy the code made of 10 numbers using the CH1 button as
0 (OFF) and CH2 button as 1 (ON).
3) Once the 10 numbers are inserted, the LED blinks 3 times indicating the end of
the registration procedure.
4) Try the new remote control.

www.ChronoRemoteControl.com
Registration of remote controls using BIXR1/ BIXR2 radio receiver :
1) Press the PRG button on the BIX receiver. A “SIG” LED turns on. The receiver
is in a “learning mode”.
2) Press one of the channel buttons on your remote control. The LED flashes.
3) Repeat the operation for each remote control (100 max).
4) 10 second after the last transmission, the radio receiver goes back to the
“normal mode”.
Note:
If JR4=ON, all channels are memorized.
If JR4=OFF, only the channel we press (CH button) can be memorized.
How to erase all registered remote controls:
Press the PRG button on the radio receiver. Hold for 3 seconds until the “SIG” LED
starts flashing.
If you wish to erase alle the remotes from radio receiver memory, repeat the action
one more time (Press the PRG button on the radio receiver. Hold for 3 seconds.).
If you only want to erase one remote control, press the previously memorized CH
button on the remote.
The quickly flashing SIG light indicates the operation was successful.