DIVERSIFIED WOODCRAFTS Shain CDTC-60 User manual

[1]
CDTC-60
ASSEMBLY INSTRUCTIONS
*Model views may not represent exact model purchased

[2]
TABLE OF CONTENTS
ASSEMBLY COMPONENTS_______________________________________ 3
LEG ASSEMBLY (ATTACHMENT OF STRETCHERS)_________________ 4
TOP ATTACMENT, ALONG WITH LEG LEVELER ATTACHMENT______ 5
UNDER DESK KEYBOARD________________________________________ 6
CPU HOLDER____________________________________________________7

[3]
ASSEMBLY COMPONENTS
ITEMS INCLUDED
PART #
PART#
1-TOP,TABLE
2-LEG,PANEL,PED,ASSY,30H
227569
8- SCREW,7MMX70MM,CONN,ALLENHEAD
237959
1-UPPER STRETCHER, LEG
228501
1-STRETCHER,LEG
227927
Accessories:
1-PT HARDWARE BAG {CONSISTS OF:}
15-0069
10-SCREW,#10X2.50 PHIL PAN SMS
227831
4-LEG LEVELER,BLK BASE 1
100079
1-BIT,1/4"HEX, #2PHILLIPS
239326
1-ALLEN,HEX KEY,ALX 5/32" LONG
236117
Accessories: {Some items may depend upon model
purchased}:
TRAY,KEYBOARD,SLIDE OUT,#KVKD100
214416
TRAY,MOUSE,KIT
232173
BRACKET,MOUNTING, CPU UNIT
232171
REV DESCRIPTION DATE
---
Original Created
6/29/10
DK

[4]
Assembly Instructions
Items not included but needed for assembly:
1. ½” wrench
Instructions:
1. Lay the table on the floor with the bottom up. (Be sure to lay the table on a clean
surface so you don’t damage the tabletop.)
2. Take each of the table legs and insert the stretcher stud through the predrilled
holes. The stretcher with the drilled holes goes on the top. Attach the stretcher
with the (8), 7mm X 70mm, conn, Allen head, screws provided (part #237959).
Pre-drilled holes (counter-
bore located on bottom)

[5]
3. Center the leg assembly over the top as pictured below. Attach the legs to the
top using the 10- screws, #10X2.50 Phil Pan SMS, zinc provided (part#227831).
4. Screw leg levelers (part #100079 into each t-nut located in the bottom each leg
assembly.
5. Turn the table over so the top is up. Set your table in place and adjust the leg
levelers to level the table.
Leg levelers

[6]
6. Next, you will need to attach the under desk keyboard which is an option to some
units. It may be easier to attach the keyboard when the table is upside down. You
will attach the under desk keyboard with the remaining hardware which is
provided. The under desk keyboard should look like the picture below once it is
completely installed. The under desk keyboard, will mount to the actual top of
the unit; center the keyboard evenly between the leg assemblies. When complete
the front of the under desk keyboard should almost be flush with the side of the
top, as pictured below.
Approx flush

[7]
7. Finally, attach the CPU holder to the side of the unit. Please see below for more
details on how the CPU holder works. If you need additional information on the
assembly on the CPU holder, please see the box that the CPU holder came
in.