DIVERSIFIED WOODCRAFTS Shain DT Series User manual

[1]
DT-TABLES
ASSEMBLY INSTRUCTIONS
*Model views may not represent exact model purchased

[2]
TABLE OF CONTENTS
ASSEMBLY COMPONENTS_______________________________________3
APRON TO LEG ATTACHMENT___________________________________4
LEG ASSEMBLY_________________________________________________5
LEG BRACES, STRETCHERS, AND LEG LEVELER___________________6

[3]
ASSEMBLY COMPONENTS
ITEMS INCLUDED
PART #
PART#
1-LEG KIT,TABLE
1-APRON ASSY,TABLE
1-TOP,TABLE
BOX,TABLES
4-SCREW,7MMX50MM,
228564
8-SCREW,7MMX90MM
227578
OPTION FOR STRETCHERS
OPTION FOR LEG BRACES
3- SCREW,#6X3/4 TRUSS HEAD,QUAD,BLACK
236263
REV DESCRIPTION DATE
---
Original Created
6-12-09
NAM
Deleted leg boot, added pencil strip, & chamfer leg
1/21/10
DK

[4]
Assembly Instructions for
Tables
Items not included but needed for assembly:
1. ½” wrench
Instructions:
1. Lay the table on the floor with the apron side up. (Be sure to lay the table on a
clean surface so you don’t damage the tabletop.)
2. Take each of the table legs and insert the stud bolt through the hole in the steel
corner brace. Please read instruction three before inserting all legs.

[5]
3. Please note: There may be either 1 or two legs with a chamfer (45) on it. The
legs with the chamfer go alongside the adjustable top as pictured below.
4. Apply a lock washer and a 5/16” nut onto each stud bolt. Tighten each nut using a
minimum of 12 foot-pounds but not exceeding 17 foot-pounds of torque.

[6]
5. Screw leg levelers into t-nut in the bottom of the leg.
6. Turn the table over so the top is up. Set your table in place and adjust the leg
levelers to level the table.
7. Add the pencil strip to the adjustable top using the (3) #6 x ¾ truss head, black
screws provided. NOTE: It is recommended to first line the pencil strip up on the
side of the adjustable top, then drill pilot holes into the side of the top to prevent
the top from splitting. 1/8” drill bit is not provided.
8. NOTE: TABLES WITH LEG BRACES AND STRETCHERS SEE
FIGURE 8A. FIGURE 8A
9. Attach leg braces with: (SCREW,7MMX90MM,CONN,ALLENHEAD,BLACK)
Provided
10. Attach stretcher with: (SCREW,7MMX50MM,CONN,ALLENHEAD,BLACK)
Provided
Stretcher
Leg Brace