DIVERSIFIED WOODCRAFTS XS-4830 User manual

 
 







 
 


PARTS LIST
HARDWARE LIST
NOTE: ALL SET SCREWS MUST BE FILLED WITH SILICONE CHAULK AFTER THE TABLE IS SETUP.
THIS IS DONE TO COMPLY WITH NSF'S EASILY CLEANABLE REQUIREMENTS.

(DETAIL A)
LEG SOCKET
(DETAIL B)
M8X8 SET SCREW
UNDERSHELF
(DETAIL C)
LEG W/ ADJ. FOOT
METAL TABLE WITH LOWER SHELF
TABLE TOP ASSEMBLY INSTRUCTIONS
1. TURN TABLE TOP UPSIDE DOWN ON A CLEAN
SURFACE TO AVOID SCRATCHING (SEE DETAIL A).
ASSISTANCE WILL BE NEEDED
2. PLACE LEGS INTO TABLE GUSSETS (LEG SOCKET).
DO NOT TIGHTEN SET SCREWS (SEE DETAIL B).
3. WITH ASSISTANCE, POSITION SHELF FACE DOWN.
GUIDE LEGS THROUGH SHELF GUSSETS UNTIL SHELF
REACHES DESIRED HEIGHT (SEE DETAIL C). MAKE SURE
SHELF IS LEVEL BEFORE TIGHTENING THE SCREWS.
TIGHTEN SET SCREWS ON SHELF GUSSETS WITH ALLEN
WRENCH (PROVIDED).
4. TIGHTEN SET SCREWS IN TABLE GUSSETS. NOTE:
AFTER TIGHTENING, THE ENDS OF THE SET SCREWS
AND GAPS AROUND GUSSETS MUST BE FILLED WITH
ANY TYPE OF SILICONE CHAULK (NOT PROVIDED) TO
COMPLY WITH NSF STANDARD 2.
5 GRASPING TABLE BY ITS TOP, TURN TABLE RIGHT
SIDE UP AND ADJUST FEET TO LEVEL THE TABLE.
6. REMOVE PROTECTIVE POLYETHYLENE FILM FROM
TABLE TOP AND SHELF
7. TABLE IS NOW READY TO USE.