DMI Sports HT250 User manual

DMI Sports For Customer Service Call 1.800.399.4402
1.800.399.4402
FAX: [phone]
Please have your model number when inquiring about parts.
Or write to:
DMI Sports
Customer Service
375 Commerce Drive
Fort Washington PA, 19034
Please visit our web site at:
www.dmisports.com
When contacting DMI Sports, please provide your model number
and item number (if applicable) if requesting a replacement part.
Item numbers can be found inside this owners manual.
Congratulations on the purchase of your new DMI Sports
Table hockey table. Our products are designed and
manufactured to give you years of game playing enjoyment.
KEEP BOX AND PACKING MATERIAL UNTIL TABLE
HAS BEEN COMPLETELY ASSEMBLED.
ALL DAMAGE MUST BE REPORTED TO DMI
WITHIN TEN DAYS OF RECEIPT.
If you have any problems with your new product,
PLEASE DO NOT RETURN IT TO THE STORE.
Please contact us:
Your Model Number
_______________________
Your model number is also located on the original carton. These instructions
are also available online at: www.dmisports.com.
HT250
0012408

DMI Sports For Customer Service Call 1.800.399.4402
Please Keep Your Instructions!
(You will need your Model number should you need to contact us.)
Before attempting assembly, please read through this instruction book to familiarize yourself with all
the parts and assembly steps. We recommend that two adults assemble this table. Please refer to the
Parts Identifi er on the following page and be sure that all parts have been included. Although extreme-
ly rare, occasionally a part may be missing. If you are missing a part, or if you have any questions, please
call our customer service department at 1.800.399.4402 Mon-Fri between the hours of 9:00am and
5:00pm E.S.T; or you can reach us at: www.dmisports.com.
Do not return the game to the store. Please contact us fi rst at: 1.800.399.4402 or on our website at:
www.dmisports.com.
IMPORTANT!
TWO ADULTS ARE REQUIRED TO ASSEMBLE
THIS HOCKEY TABLE
DMI Sports For Customer Service Call 1.800.399.4402-2-DMI Sports For Customer Service Call 1.800.399.4402

DMI Sports For Customer Service Call 1.800.399.4402
PARTS IDENTIFIER
HARDWARE PARTS
A1
A2
Pusher
RPHT-PUSH
Qty. 4
Qty. 2
ACCESSORY PARTS
DMI Sports For Customer Service Call 1.800.399.4402
-3-
DMI Sports For Customer Service Call 1.800.399.4402
H1
H2
H3
H4
Leg Bolt
RPHT250-HKIT
Washer, Leg
RPHT250-HKIT
T4x25mm Bolt
RPHT250-HKIT
Qty. 16
Qty. 16
Qty. 8
Qty. 10
TOOLS REQUIRED FOR ASSEMBLY:
• Phillps Head Screw driver-
Not Included
• Level recommended-
Not Included
•
Wrench
- Included
T3.5x12mm Screw
RPHT250-HKIT
Goal Flex™ Puck
RPHT-GFPUCK
A3
Qty. 1
ASSEMBLY PARTS
P1
P2
P3
P4
Main Frame
RPHT250-FRAME
Left Leg
RPHT250-LLEG
Qty. 1
Qty. 2
Qty. 2
Qty. 2
Right Leg
RPHT250-RLEG
Panel, Leg
RPHT250-LEGPANE
Wrench
RPHT-AWRENCH
P5
Qty. 2
Goalfl ex80™ Goal
RPHT250-GOAL
P6
Qty. 1
Goalfl ex80™ Console
RPGF80-CONSOLE
H5
Qty. 6
T3.5x18mm Screw
RPHT250-HKIT
Console Holder
RPHTGF80-HOLDER
P7
Qty.1

DMI Sports For Customer Service Call 1.800.399.4402
DMI Sports For Customer Service Call 1.800.399.4402
-4-
DMI Sports For Customer Service Call 1.800.399.4402
ASSEMBLY
STEP 1.
Place two Left Legs (P3) and Right Legs (P4) on fl at surface with six pre-drilled holes facing up.
Using four Screws (H3), attach to Leg Panel (P2). Repeat for second set of legs.
STEP 2.
Place Main Frame (P1) UP-SIDE-DOWN on carton. Attach assembled Leg & Leg panels to Main Frame (P1)
using sixteen Leg Bolts (H1) and sixteen Leg Washers (H2). Place washers on leg bolt and screw to leg
through holes in underside of table. Tighten all bolts with fi ngers, then tighten with wrench provided.
NOTE: Please leave Main Frame (P1) face down in the carton that it ships in until the legs are attached.
All images are shown UP-SIDE-DOWN until the table is turn up on its legs. Unpack all contents and lay
out on the fl oor. Verify all parts listed on parts identifi er are present.
FIG 1.1
FIG 1.1
P2
P2
P4
H3
H3
H1
P1
H2
Note: Do not turn table over during
Note: Do not turn table over during
assembly without assistance. Apply-
assembly without assistance. Apply-
ing sideways pressure on the legs
ing sideways pressure on the legs
will result in breakage, which is not
covered by the warranty.
FIG 2.1
FIG 2.1
P3

DMI Sports For Customer Service Call 1.800.399.4402
STEP 3.
Carefully turn table upright with assistance.
STEP 4.
Attach Goalfl ex 80™ Goal (P9) to both ends of the table as shown in Fig. 3.1 using eight Screws (H4) in the
pre-drilled holes in the ends of the table. Be sure to run the wires through the space provided between
the play surface the the end panel as shown in Fig. 3.1. Attach the Console holder (P7) to the side panel
with the hole in it using Screw (H4). Attach the Electronic console (P6) to the holder. Run the two wires
from the electronic console down through the holes before securing the console using Screw (H4) and
attach the console wires to the wires from the Goalfl ex 80™ goal system beneath the table.
attach the console wires to the wires from the Goalfl ex 80™ goal system beneath the table.
DMI Sports For Customer Service Call 1.800.399.4402-5-DMI Sports For Customer Service Call 1.800.399.4402
ASSEMBLY
FIG 3.1
H4
H4
H4
P4
P7
H4
P6
P5

DMI Sports For Customer Service Call 1.800.399.4402
REF
H1
H2
H3
H4
H5
P2
P3
P4
P5
P6
P7
A1
A2
A3
PART#
RPHT250-HKIT
RPHT250-HKIT
RPHT250-HKIT
RPHT250-HKIT
RPHT250-HKIT
RPHT250-LEGPANE
RPHT250-LLEG
RPHT250-RLEG
RPHT250-GOAL
RPGF80-CONSOLE
RPHTGF80-HOLDER
RPHT-PUSH
RPHT-GFPUCK
RPHT-MWRENCH
RPHT250-CORNER
RPHT-MOTOR5
DESCRIPTION
Leg Bolt
Leg Washer
T4x25mm Bolt
T3.5x18mm Screw
T3.5x12mm Screw
Leg Panel
Left Leg
Left Leg
Right Leg
Right Leg
Goalfl ex 80™ Goal
Goalfl ex 80™ Console
Console Holder
Pusher
Goal Flex™ Puck
Multi Wrench
Plastic Corner
Motor
UNIT
PRICE
TOTAL
AMOUNT
Subtotal:
PA Residents Add 6% State Sales Tax:
Shipping and Handling Charges:
TOTAL:
(ea.)
(ea.)
(ea.)
(ea.)
(ea.)
(ea.)
(ea.)
(ea.)
(ea.)
(ea.)
(ea.)
(ea.)
(ea.)
(ea.)
(ea.)
(ea.)
PARTS RE-ORDER FORM
HT250 Table Hockey table
DATE:
NAME:
ADDRESS:
CITY:
PHONE:
STATE:
ZIP CODE:
Send this form along with your
check or money order payable to:
DMI SPORTS
375 Commerce Drive
Fort Washington, PA 19034
www.dmisports.com
.25
.25
.50
.25
.25
9.00
10.00
10.00
40.00
40.00
5.00
2.00
1.00
1.00
8.00
25.00
SHIPPING AND HANDLING:
Up to $15.00 add $2.00 for S&H
Over $15.00 add $8.00 for S&H
Console add $5.00 for S&H
QTY
16
16
8
10
6
2
2
2
2
1
1
4
2
1
4
1