Dock N Stow GEN1 User manual

Thank you for purchasing a Dock N Stow product!
GEN1 Operation and Instruction
•Remove back of silicone rubber tape and apply to the center channel on bottom of block (prevents slipping on frame). Tape should
be applied after your spacers (if required) are in place to ensure the tape is centered and wouldn’t interfere with spacers ability to
snap in place.
Step 3- Attach silicone non-slip tape
Step 4 - Remove top insert if necessary for use with caster wheel
•If a wheel is on bottom of your jack post, remove top insert for wheel dock using Phillips head screwdriver.
Read All Instructions! Failure to Follow All Instructions Listed Below May Result in An Unsafe or Dangerous
Condition.
Contents of package: 1 Dock N Stow; 4 grey spacers; 1 adjustable flat bungee; 1 adhesive backed silicone rubber strip.
Dock N Stow Assembly:
Step 1 - Determine trailer frame location you will be using for your new frame mounted Dock N Stow stabilizer block. This location will need 7 inches of space.
Step 2 - Measure the top width of the trailer frame; This measurement is used to determine how many spacers are needed for your frame size.
•3-inch trailer frame requires no spacers.
•2.5 inch trailer frame requires two spacers. One spacer will be used on either side of the channel at the bottom of the block.
Slide spacers into dovetail grooves until they snap into the bottom ofthe block.
•2inch trailer frame requires four spacers.Two spacers will be used on either side of the channel at the bottom of the block.
Slide spacers into dovetail grooves until they snap into the bottom ofthe block.

Usage: When ready to use Dock N Stow, make sure ground is level.
•Place Dock N Stow under trailer tongue jack. Lower jack and ensure post is centered on Dock N Stow and stable.
•Dock N Stow works with virtually all trailer tongue jacks; round, square, post, wheel.
Storage:
WheelPostRound Foot Square / Rectangle Foot
Step 1 - Place Dock N Stow on top of the frame rail of trailer.
Step 2 - Place hook end of bungee cord in one of the two slots on-top of block (see photo A) Take other end, going under trailer frame and back up to the opposite
side of block placing hook end into opposite slot (see picture B). Adjust bungee tension to apply strong downward pressure to securely fastened block to frame to limit
movement.
Picture A Picture B
WARNING
Failure to read, understand, and follow all instructions before using this device may result in personal injury or property damage.
WARNING
Visually inspect equipment prior to each use. If damage is apparent, remove from service. Prolonged exposure to sunlight can cause device to weaken. Always use
brake. Chock all tires on trailer, both in front and behind tires prior to use. Use only on hard, level surfaces. Never place yourself under or behind unstable
vehicles. Do not exceed the rated weight. Center the load on the Dock N Stow. Ensure the jack foot or post is flush with surface of Dock N Stow. Do not make any
alterations to this product. Not to be used on any trailer with I-beam or C-channel construction. Not to be used on any trailer with less than a 2-inch-wide trailer
frame or greater than 3-inch wide trailer frame. When not in use, securely fasten the Dock N Stow to the frame of the trailer prior to travel. Inspect bungee cord
before each use, replace annually or as needed. Not intended for commercial use or with heavy commercial-type trucks or trailers. Failure to heed warnings may
result in personal injury and/or property damage. User assumes all risk for the proper use of this device and for ensuring product suitability for intended
application and safe securement to trailer before traveling.
Visit us: DockNStow.com
Dock N Stow Limited Warranty
Dock N Stow products are covered by a One Year Limited Warranty on Material and Workmanship. Warranty is Non-Transferable. Dock N Stow reserves the right to
inspect all product claims under warranty. Any alteration of the device voids this warranty. This warranty shall not cover any incidental or consequential damages
due to the improper use or failure of this device.