Technical User Guide
DOL 40R www.dol-sensors.com 3
4 User Guide
Activated
Not active
Red
Green
Sensor
No time delay
Delayed
disconnection
Delayed
connection
Red
Red
Green
Green
DOL 41R has no time delay.
DOL 43R has an option for delayed disconnection. Time delay
starts When the activation stops (red flash) When this time stops,
the relay switches back.
DOL 45R has Apart from the settings mentioned above, also has
the option of delayed connection. The time delay starts when the
sensor is affected. When the delay period runs out, the relay will
switch. The relay does not switch back until the activation stops.
Sensitivity Delayed disconnection Delayed connection
41R
43R
45R
DOL
The sensitivity and the delay length are adjusted by two switches. LEDs indicate when the switches are acti-
vated.
Sensitivity adjustment (DOL 41R / 43R / 45R)
press 1 x A+B simultaneously
press A or B for -0,2mm +0,2mm
DOL 41R settings is completed press A+B
DOL 43R and DOL 45R continue to the next setting by press A+B
Time delay setting (DOL 43R/45R)
Press A or B for +1 minute +1 seconds
Eksempel 1xA + 5xB = 65 seconds
DOL 43R settings is completed press A+B
DOL 45R continue to the next setting by press A+B
On / off delay (DOL 45R)
press A or B for delayed on or off
press A+B simultaneously = settings completed
Status
Red: sensor is affected
Green: sensor is unaffected
Yellow: Error
Flash: Time delay
Special functions
Factory setting: Hold A + B simultaneously for 15 seconds
Show delay Hold A + press 2xB (Red = 1 min. Green = 1 sek.)
Change delay: Hold A + press 4xB (+10 sec.) hold A + 5+B (÷5 sec.)
Hold A + 6+B (+1 hour.)
Switch off delay.: Hold A + press 7xB
switch off LED Hold A + 8xB
Switch on LED Hold A + 9xB
