Dollken HKP 220 User manual

Instruction manual
Always wear heat-protective
gloves when carrying out the
work steps described below!
Hot-melt
adhesive gun
Changing the
hook nozzle
Caution
Tools required
Spanner
Fühlerlehre
feeler gauge
Version: 01.02.2021

Tapeteneckleisten
TEL 20 /
Tapeteninnenwinkel
TIW 20
Heat up the device!
Disconnect the unit from the
mains by pulling the mains
plug.
Unscrew the defective hook
nozzle over a suitable surface.
Do not operate the trigger
under any circumstances to
avoid uncontrolled adhesive
leakage.
Screw on the new
hook nozzle hand-tight.
The device can then be put
back into operation immedia-
tely.
1
2
3
4
Döllken Profiles GmbH
Industriestraße 1
59199 Bönen
Follow us on
T: [phone]
F: [phone]
info@doellken-profiles.com
www.doellken-profiles.com
Caution
The hook nozzle is designed for gluing
the back of the skirting boards.
Protect from impacts and bending!
!
loosen
tighten
Screw down the
contour nut