DOM 479 User manual

2
WARNING!
Avoid serious injury from falling or sliding out. Always use Restraint System. Your child's safety
depends on you. Proper stroller use cannot be assured unless you follow these instructions.
DO NOT USE STROLLER UNTIL YOU READ AND UNDERSTAND THESE INSTRUCTIONS.
IMPORTANT SAFETY INFORMATION
•ADULT ASSEMBLY REQUIRED.
•NEVER LEAVE YOUR CHILD UNATTENDED WHILE IN STROLLER. Accidents
can happen quickly while your back is turned. You must always keep your child
in view while your child is in the stroller, even when sleeping. Do not use this
product as a bed. Your child may become tangled in straps or pads and suffocate.
•Always use restraint system to keep child from standing up or falling out of the
stroller. Do not use product without full 5-point restraint harness. Removing the
shoulder straps will not adequately restrain your child.
•Always place your child in the front seat before placing your other child in
the back seat. When removing children, always remove the child in the back
seat first before removing the child in the front. Failure to do so may cause the
stroller to become unstable and tip.
•Always lock the stroller open before allowing your child in or near the stroller.
This prevents injuries caused by stroller collapsing.
•Only use this stroller with children who weigh less than 40 lbs. (18 kg) per seat.
This stroller can hold a maximum of 80 lbs (36 kg.) dual occupancy. Using this
stroller with heavier children may cause it to tip.
•Use this stroller in the reclined position until child can sit up unassisted.
•Always set the wheel brakes when you aren't pushing the stroller, especially
on an incline. This prevents the stroller from rolling away.
•Always fasten the canopy onto the back of the seat when using the stroller in the
reclined position.
WARNING!
What to Avoid While Using this Stroller:
• Always balance the weight of the stroller evenly. To prevent the stroller from
becoming unstable or tipping:
• Do not place parcels or accessory items on the stroller canopy, seat, or over the
handle.
• Do not put more than 10 lbs. (4.54 kg) in the basket.
• Do not allow children to play with or hang onto the stroller.
• When using this product with only 1 child, only use the seat in the front position.
• Never use this stroller on stairways or escalators.
• DO NOT lift by the front bars.
• THIS IS NOT AN EXERCISE STROLLER! Do not use this product
while running, jogging, in-line skating or participating in other athletic activities.
• DO NOT put child in basket.
How to Keep Your Child Safe While Using this Stroller

3
Parts List
Stroller Frame Basket Tube Stroller Handle Parent Tray
Washers (2)
Cotter Pins (2)
Rear Wheels (2)
Front Bars Hub Caps
Reversible Seats Pins (2) Screws (6)
Brake Assembly
with Rear Axle
Front Wheels (2)

4
HOW TO ASSEMBLE YOUR STROLLER
To Open Stroller
1. Remove any cardboard inserts or plastic ties used to protect the product during shipment.
2. Release the locking latch on the Stroller Frame.
3. Unfold to full open position.
4. Remove the sticker from the Front Wheel Assembly. Remove and discard both screws from
the Front Wheel Assembly.
5. Rotate Front Wheel Assembly upward, until you hear a click.
6. Secure the Front Wheel Assembly into the stroller frame with 2 notched Pins.

5
To Attach Basket
1. Align the Basket Tube with the Basket Frame
in the rear of the stroller as shown.
2. Press in spring loaded buttons on Basket Tube and
slide into the Basket Frame until both buttons click into
place.
3. Unroll the basket over center bar of stroller frame as shown.
4. In the middle & front of the stroller, secure the 4
sets of snaps on the basket around the stroller frame.
5. Secure the 6 sets of snaps at the back end of the
basket around the Basket Tube as shown.

6
To Attach Stroller Handle
1. Slide the Stroller Handle down to the stroller frame
until the holes on each side of the Stroller Handle can be
seen in the frame.
2. Secure the Stroller Handle with a screw on each side
of the frame.
To Attach Parent Tray
WARNING
Do not place more than 3 lbs. (1.36 kg) in this tray to avoid
tipping. Do not place hot liquids in this tray. Hot liquids can
burn your child.
1. Place the Parent Tray onto the bar underneath the Stroller Handle and align
the Parent Tray into the 4 holes. The Parent Tray should be positioned so the lid
opening is towards the handle.
2. Secure the Parent Tray to the bar with 4
screws as shown.
To remove Parent Tray, simply unscrew from frame.
For cleaning, Parent Tray is top rack dishwasher safe.

7
To Attach Front Wheels
1. Align Front Wheel as shown.
2. Push Front Wheel up into the Front Wheel Assembly
until a “Click” is heard.
3. Repeat for other wheel.
Tug firmly on each wheel assembly to be sure wheels
are securely in place.
NOTE: To remove Front Wheels, twist the top of the Front Wheel Assembly as shown,
and pull the wheel off.
To Assemble Rear Wheels
1. Turn stroller over as shown. Remove protective sleeve from ends of brake assembly
with rear axle.
2. Position Brake Assembly as shown, with brake levers pointing towards stroller handle.

8
3. Push both brake assemblies onto rear leg tubes at
the same time until spring loaded buttons click into
place.
NOTE: If brake assemblies do not click and hold in place, the spring button
may be stuck, not protruding through the hole in the tube. Use a
screwdriver or pliers to move the button so that it protrudes out of the hole
in the tube.
4. Slide Rear Wheel onto axle.
5. Slide Washer onto axle.
6. Fit the straight part of the Cotter Pin
through hole on axle as shown.
7. Line up tabs in the Hub Cap with slots in
the wheel, snap hub cap into place.
8. Repeat for second side.

To Attach Reversible Seats
WARNING
When using this product with only one child, only use the E seat position.
Reversible Seats can be positioned in
these directions:
A. Facing Parent
B. Facing Away from Parent
C. Facing Each Other
D. Back to Back
E. One child Use (Seat must be
attached on front frame hub to avoid
tipping)
1. Align Reversible Seat catches over frame hubs as
shown and push Reversible Seat down onto the
frame hubs until a “Click” is heard on both sides.
2. The button on the frame hubs should be seen through both Reversible Seat catches.
Pull up on the seat to make sure the seat is securely attached.
9
3. Repeat steps 1 and 2 for the other reversible seat.
NOTE: To remove reversible seat, push both buttons on the frame hub in, that lift the
Reversible seat up.

To Attach Front Bars
CAUTION
To prevent injury to your child, take care when inserting bar into frame.
1. Align Front Bar pins over the holes on the Seat
Catch and push in until a “Click” is heard on both sides.
Repeat this step for other Front Bar.
2. To let a child in/out of a Reversible Seat, push on
one side of the Front Bar, release button, and pull the
Front Bar out. The Front bar will now swivel outward.
Repeat step 1 to reinsert Front Bar.
To remove Front Bar, push both Front Bar release buttons and pull out.
Repeat step 1 to reinsert.
10

HOW TO PROPERLY USE YOUR NEW STROLLER
To Operate Brakes
1. Push levers on both rear wheels down to lock.
2. Pull levers up to unlock.
To Secure child in Stroller Seat
WARNING
Avoid serious injury from child falling or sliding out. Always use restraint system.
Do not use product without full 5 point Harness Restraint.
1. Lock foot brake to keep stroller from rolling.
2. Place child in stroller.
3. Hook shoulder straps to waist belt.
11
5. To unsnap restraint system buckles – press
tabs to release.
6. For proper fit, adjust shoulder straps and waist
band as shown.
4. To fasten restraint system buckles – push together.
Be sure both buckles are fastened to secure child safety.

To Adjust Shoulder Strap Height
NOTE: For a secure fit, straps should be at or below the child’s shoulder.
Adjust straps to higher positions as your child grows.
3. From the back side of the stroller, fasten buckles together to
secure restraint.
12
2. Position the buckle to a higher position and push the
buckle through the slot as shown. Repeat for second side.
1. To readjust shoulder restraints, unbuckle the back of
the seat and push the buckle back through

To Install Infant Neck Roll
Infant neck roll is to be used with newborns who can
not hold their head up. It should be used only when the
seat is reclined. It can be removed when a child can
hold their head up unassisted.
When using the infant neck roll, be sure that the
shoulder restraint straps are fed through the holes on
either side. Restraint must always be used with the
infant neck roll.
To Adjust Footrest
Footrest can be adjusted for child's comfort. Push in side buttons to adjust.
To Recline Seat
WARNING
To avoid finger entrapment or pinching, do not adjust the back of the seat while child
is in the stroller. To avoid head entrapment, always fasten the canopy to the back of
the seat when using the stroller in the reclined position.
13

1. To recline seat, pull adjustment bar located on
the top of the seat to one of 4 positions:
• Upright
• Middle (2 positions)
• Full Recline
NOTE: For both seats to recline fully, the seats are
best positioned when facing parent or facing away
from parent. Footrests may need to be adjusted for
child’s comfort.
2. Make sure that the Velcro on the canopy is
secured to the back of the seat while the seat is in
the reclined position.
Hold-On Handles
Hold-on handles are designed to be used with older
children walking beside parent.
14

2. For the tightest fold, either:
a) Remove rear seat facing the handle. OR
b) Remove front seat and make sure Rear
Seat is facing forward.
3. Close canopy.
4. Pull up on triggers and push stroller handle
forward slightly.
5. Step down on the basket lever with your foot and
push the stroller handle forward, folding the stroller.
6. Engage locking latch.
15
To Fold Stroller
1. Lock the brakes.

7. Remove Reversible Seat restraint straps from
pockets in basket.
8. Place the removed seat facing other seat and tuck
it in front of the tray. Secure it with the belts to keep it in
place. Make sure that the belts are secure especially
when using to travel.
9. Stroller should be able to stand up right
when folded properly.
Care and maintenance
To keep your stroller running smoothly and to avoid squeaky wheels, use a silicone or
graphite based lubricant. It is important to get it into the axle and the wheel assembly.
Clean the metal parts with a damp cloth and wipe dry. Clean woven fabric or vinyl parts
with mild soap and water solution. Dry the wet stroller with a soft cloth to prevent rusting.
When storing the stroller, never stack other items on top of it; this may damage the stroller.
Periodically check for worn parts, loose screws, torn materials or stitching. Replace any
damaged parts immediately.
16

Thank you for choosing Dream On Me and congratulations on
joining The DOM Family, a family that has been transforming lives
for 30 years! We appreciate your feedback and wish you the very
best in the coming years with your new addition. If you have any
questions or concerns please don’t hesitate to reach out and a
trusted DOM representative will assist you. Thank you again for
entrusting us to supply you with the safest, functional and
affordable baby products and accessories. Feel free to follow us
on Facebook and Instagram for further opportunities and offers.
Dream On Me Inc.
1532 S Washington Ave Piscataway Twp. NJ 08854
Tel: [phone]
Fax: [phone]