LED Battery Mode Definition
Solid light Power on mode
Blinking light Sleep/Reserve mode
OFF Power off mode
LED (POWER BUTTON) INDICATORS
CAN PORT WIRING
HOW TO USE
NOTE:
To prevent a surge current, perform a “pre-discharge” as outlined
in the steps below.
Batteries are in Power Off mode when unboxed. Press the Power button
for 3 seconds to turn on. If it doesn’t turn on, you will need to charge
the battery.
The batteries need to be configured before they can be used. Please see
battery manual for instructions on battery configuration.
VARIOUS POWER MODES
Step 1 - Ensure all batteries are in Power Off mode.
Step 2 - Connect batteries following the series or parallel connection diagrams
found at gopowersolar.com/advanced-lithium-wiring. Cable 2 must
be installed for each battery pack followed by a Cable 3 cable on the
last battery.
Step 3 - Ensure battery pack terminals are correctly installed and connected to
the inverter system.
Step 4 - Press the power button on one of the battery packs for 3 seconds to
wake up all battery packs from Power Off mode. The LED indicator
will turn on.
Cable 1
Cable 2
INTERFACE DESCRIPTION
Reserve
Capacity
Reserve
Capacity
Power off
Press and hold for 3s and release
Press and hold for 8s and release
Press and hold for 8s and release
Press and hold for 8s and release
Press and hold for 3s and release
Press and hold for 3s and release
Press and hold for 3s and release
or charge battery to above 5Ah
Press button for more than 3 seconds and release. The battery will enter sleep
mode. The LED will blink. Power off mode should only be used for long term
storage or to reset the BMS. Use sleep mode to disable output power of batteries.
Scan the QR code to download the Go Power! Connect App
for use with the Sun Cycle®Advanced Lithium Battery.
BLUETOOTH®APP
RV-C system
(if applicable)
Cable 3
Power on
Power on
Power on
Power off
Power off
Sleep Mode
Sleep
Mode
