DoorKing Microplus User manual

microplus / microclick - transmitters
Interference Information
This equipment may interfere with radio communications, AM/FM radio and TV
reception. Use the following suggestions to correct the interference:
• Relocate the receiving antenna.
• Increase the space between the equipment and transmitter receiver.
• Connect the equipment into another outlet, different from the transmitter
receiver.
• Consult a technician for help.
This equipment has been certified to comply with the limits for a class B comput-
ing device, pursuant to FCC Rules. To maintain compliance with FCC regulations,
shielded cables must be used with this equipment. Operation with non-approved
equipment or unshielded cables may result in interference to radio and TV recep-
tion.
This Class [B] digital apparatus meets all requirements of the Canadian Interfer-
ence-Causing Equipment Regulations. Cet appareil numrique de la classe [B] re-
specte toutesles exigences du Reglement sur le materiel brouilleur du Canada.
FCC Compliance
This device will provide reliable remote access control. Be aware of the following
limitations:
• This device complies with FCC Rules and Regulations, Part 15 and Canadian In-
terference Causing Equipment Regulations. Because of this, they have limited
transmitter power and limited range. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, (2) this device
must accept any interference received, including interference that may cause
undesired operation.
• The receiving device cannot respond to more than one transmitted signal at a
time. Radio signals near the receiver operating frequency may block the trans-
mitter signal regardless of the code setting. If this occurs, the radio receiver
may have to be repositioned.
• Any changes or modifications may void compliance with FCC Rules and Regula-
tions.
DoorKing’s transmitters are ideal for applications that require
RF wireless access. Users can remain comfortably inside their
vehicle while activating the RF transmitter without having to
use a keypad or card reader. When activated a data stream is
sent to the remote SuperHet receiver. This data includes the
transmitter serial number, facility code, and button code. In
addition MicroPLUS transmitters have an encrypted sync-
code that changes each time the transmitter is used.

For warranty information please contact
DKS, DoorKing Inc.,
120 Glasgow Avenue, Inglewood, Ca. 90301, 310.641.1589





 



Battery Replacement
When a malfunction is suspected,
replace the battery, using a 12-volt
Duracell type MN21 battery, or
equivalent.
1. Remove the phillips screw from
the back of the transmitter.
2. Carefully remove the old battery
and install the new battery, check
for correct polarity.
3. Reinstall the top of the transmit-
ter and phillips screw, do not over
tighten.
Transmitter Operation
Maximum transmitter range is 75-
100 feet. Obstructions may aff ect
operating range.
1. Press the transmitter button for 2
seconds to send a signal, the red
light will light-up.
2. The transmitter sends a signal (20
second for MicroPLUS), (2 second
for MicroCLICK) preventing the
transmitter from jamming the re-
ceiver if the button becomes stuck
in the ON position.
8069-065-B-05-06