Drag2Zero D2Z-BTA-0001 User manual

BTA Bottle mount assembly
instructions

Parts list
M5 Flat Washers
(x2)
M5 10mm Flanged
Button screws (x4)
M5 Square nuts
(x4)
*Already installed into the
bottle mount
M5 16mm Caphead
screws (x2)
M5 Nylock nuts (x2)
*Already installed into the bottle
mount
D2Z BTA Bottle mount
(x1)

Measurements
Part Name
Dimension A (outside to
outside armrest width) Dimension B (Front width for reference)
Dimension C (width of BTA
mount for reference)
θ
D (°
) between pad
and mount
D2Z-BTA-0001 230mm 216mm 20mm 0
D2Z-BTA-0003 240mm 224mm 30mm 0.75
D2Z-BTA-0005 250mm 232mm 40mm 1.5
D2Z-BTA-0007 260mm 240mm 50mm 2.25
D2Z-BTA-0009 270mm 248mm 60mm 3
D2Z-BTA-0011 280mm 256mm 70mm 3.75
*Bottle mount flex
allows for
approximately ±5mm
of tolerance for outer
pad widths (A and B)*
e.g if outer pad width is 240mm, then D2Z-BTA-0003 is the correct size.
*Bottle mount flex allows for approximately ±5mm of tolerance for outer pad widths.
A
C
B
D
θ

Step 1: Drill holes in the relevant positions on armrest (6mm drill bit)
To align the holes perfectly, place armrest in the desired position on the
bottle mount and mark holes as seen below
We suggest that you take off the armrests from the cockpit if they are
already installed in order to drill accurately

Step 2: Insert M5 flanged screws into armrests

Step 3: Place bottle cage on top by aligning the holes of the cage with
the holes in the mount

Step 4: Place washers and M5 16mm Caphead screws into the top holes
to secure cage

Step 5: Tighten all screws

Step 6: Insert bottle

Drag2Zero Limited
Silverstone Sports Engineering Hub
Unit 1129 Silverstone Park, Buckingham Road
Silverstone, Northamptonshire, NN12 8FU, UK
Follow us on Twitter, Facebook, Instagram @drag2zero
Tel: [phone]
Email: [e-mail]
© Drag2Zero Limited 2020