Drinking Fountain Doctor EFTLA8 1E Instruction and safety manual

PAGE 1 97400C (Rev. F - 12/03)
EFTLA8, 14*1E LFTLA14*1E, 3E LFTLA20F*3E
With FLEXI-GUARD®
Installation/Care/Use Manual
USES HFC-134A REFRIGERANT
FIG. 1
SEE FIG. 4 7
7
36
SEE FIG. 3
38
40
22, 23,
24, 25, 41
16, 17, 18,
19, 20
15
39
SEE FIG. 4
SEE FIG. 3
37
14
31
21
29
26
30
27, 33, 34
13
35
32, 33,
34
28
42
43, 44
42

PAGE 2
97400C (Rev. F - 12/03)
EFTLA8, 14*1E LFTLA14*1E, 3E LFTLA20F*3E
FIG. 2
E = INSURE PROPER VENTILATION BY MAINTAINING 4" (102mm) (MIN.) CLEARANCE FROM CABINET LOUVERS TO WALL.
ASEGURE UNA VENTILACIÓN ADECUADA MANTENIENDO UN ESPACIO E 4" (102mm) (MÍN.) DE HOLGURA ENTRE LA REJILLA DE VENTILACIÓN DEL MUEBLE Y LA PARED ASSUREZ-VOUS UNE BONNE VENTILATION EN GARDANT 4" (102mm) (MIN.) ENTRE LES ÉVENTS DE LENCEINTE ET LE MUR.
F = POWER CORD 4 FEET (1219mm) LONG
CABLE ELÉCTRICO DE 4 PIE (1219mm), DE LARGO CORDON DALIMENTATION 4' (1219mm)
FINISHED FLOOR PISO ACABADO PLANCHER FINI
LEGEND/LEYENDA/LÉGENDE A = RECOMMENDED WATER SUPPLY LOCATION 3/8 O.D. UNPLATED COPPER TUBE CONNECT STUB 1-1/2 IN. (38mm) OUT
FROM WALL SHUT OFF BY OTHERS
SE RECOMIENDA UBICAR ELTUBO CORTO DE CONEXIÓN AL TUBO DE COBRE SIN CHAPAR DE 3/8" DE DIÁM. EXT.A 1-1/2"
(38mm) FUERA DE LA LLAVE DE PASO EN LA PARED COLOCADA POR TERCEROS.
EMPLACEMENT RECOMMANDÉ D'ALIMENTATION EN EAU PAR TUBE EN CUIVRE NON PLAQUÉ DE 3/8 PO. (9,5 mm) D.E.
CONNECTANT UNE TUYAUTERIE DE 1-1/2 PO. (38mm) DEPUIS LE ROBINET D'ARRÊT FOURNI PAR D'AUTRES.
B = RECOMMENDED LOCATION FOR WASTE OUTLET 1-1/2 O.D. DRAIN
UBICACIÓN RECOMENDADAPARA EL DRENAJE DE SALIDA DE AGUA, DE 1-1/2 DE DIÁMETRO. EMPLACEMENT RECOMMANDÉ POUR LE DRAIN DE D.E. 1-1/2" DE SORTIE DEAU.
C = 1-1/2 TRAP NOT FURNISHED**
PURGADOR DE 1-1/2 NO PROPORCIONADO** SIPHON 1-1/2 NON FOURNI**
D = ELECTRICAL OUTLET LOCATION
UBICACIÓN DE LA TOMA DE ELECTRICIDAD EMPLACEMENT DE LA PRISE DE COURANT

PAGE 3 97400C (Rev. F - 12/03)
EFTLA8, 14*1E LFTLA14*1E, 3E LFTLA20F*3E
FIG. 3 FIG. 4
NOTE:
WHEN INSTALLING REPLACEMENT BUBBLER
AND PEDESTAL, TIGHTEN NUT (ITEM 12) ONLY
TO HOLD PARTS SNUG IN POSITION.
DO NOT OVER TIGHTEN.
BASIN
9
10
11
12
8
Stream height is factory set at 35 PSI. If supply
pressure varies greatly from this, remove items
1 and 2 and adjust screw on item 4. Clockwise
adjustment will raise stream and counter-
clockwise adjustment will lower stream. For
best adjustment, stream should hit basin
approximately 6-1/2" (165mm) from bubbler.
BASIN
4
3
1
5
6
2
When provided
1
6
7
2
43
5
ITEM NO.
Filter Head Assy
Screw #8-18 X .75 PH
Fitting - Superseal 3/8 (10mm)
Fitting - Superseal 1/4 (6mm)
Filter Assy
Elbow - 3/8 (10mm)
Bracket
1
2
3
4
5
6
7
51294C
70792C
70823C
70822C
51299C
70818C
22490C
DESCRIPTION
PART
NO.
DESIGN 2000®FILTER PARTS LIST
FIG. 5

PAGE 4
97400C (Rev. F - 12/03)
EFTLA8, 14*1E LFTLA14*1E, 3E LFTLA20F*3E
ELKAY MANUFACTURING COMPANY  2222 CAMDEN COURT  OAK BROOK, IL
PRINTED IN U.S.A.
PARTS LIST 115V
ITEM NO. PART NO.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
*22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
45
46
40089C
40048C
15005C
61313C
40169C
50986C
20776C
20713C
56073C
40322C
56011C
55997C
75580C
31513C
31503C
35886C
66417C
66432C
21516C
31490C
31492C
30664C
20239C
70018C
66202C
66203C
35762C
35775C
31027C
35840C
35843C
31797C
35768C
194243901550
55996C
45702C
66229C
66445C
66505C
66506C
70682C
40022C
40088C
50368C
70750C
See Color Table
See Color Table
See Color Table
See Color Table
See Color Table
See Color Table
35844C
56092C
27961C
100322740560
15009C
Cover
Button
Regulator Retaining Nut
Regulator
Hex Nut
Regulator Holder
Basin
Basin (GF Only)
Bubbler Assy
Orifice Assy
Housing Assy
Pedestal
Bubbler Locknut
Cold Control
Power Cord (8 GPH)
Power Cord (14 GPH)
Condenser (8 GPH)
Condenser (14 GPH)
Fan Shroud
Fan Motor (8 GPH)
Fan Motor (14 GPH)
Fan Blade
Fan Bracket
Fan Blade Nut
Drier (8 GPH)
Drier (14 GPH)
Compressor Serv. Pak 8 GPH
Compressor Serv. Pak 14 GPH
Overload/Relay Assy. (8 GPH)
Overload (14 GPH)
Relay (14 GPH)
Relay Cover (8 GPH)
Relay Cover (14 GPH)
Electrical Shield
Strainer
Tailpipe Assy
Heat Exchanger (8 GPH)
Heat Exchanger (14 GPH)
Evaporator (8 GPH)
Evaporator (14 GPH)
Fitting - Tee
Waste Connection Assy
Tailpipe Assy
Receptor - Drain
Clamp
Panel-Left Side (Right Unit)
Panel-Right Side (Right Unit)
Panel-Front (Right Unit)
Panel-Left Side (Left Unit)
Panel-Right Side (Left Unit)
Panel-Front (Left Unit)
Capacitor (14 GPH)
Poly. Tubing (Cut To Length)
Bracket - Strain Relief
Gasket
Nipple - Bubbler (GF Only)
DESCRIPTON
Item No. 35
Part No.
COLOR TABLE
Gray Beige
Almond
Stainless Stl
Sandalwood
Granite
Light Gray
20623C
21461C
20625C
21459C
27168C
N/A
20657C
20658C
20654C
21450C
27147C
27148C
PANEL
COLOR
Item No. 36
Part No. w/ hole)
Item No. 38
Part No.
Item No. 39
Part No.
Item No. 37
Part No.
20646C
21468C
20648C
21466C
27177C
27178C
20736C
21479C
20737C
21478C
27189C
27190C
Item No. 40
Part No.
20684C
20685C
20681C
21456C
27153C
27154C
20724C
21475C
20725C
21474C
27183C
27184C
*INCLUDES RELAY & OVERLOAD. IF UNDER WAR-
RANTY, REPLACE WITH SAME COMPRESSOR USED IN
ORIGINAL ASSEMBLY.
NOTE: All correspondence pertaining to any of the above
water coolers or orders for repair parts MUST include Model
No. and Serial No. of cooler, name and part number of re-
placement part.
36024C
31431C
35856C
35953C
35954C
35955C
27962C
35826C
14
17
22*
23
41
43
44
Power Cord
Fan Motor
Compressor Serv. Pak
Overload
Relay
Capacitor
Bracket - Power Inlet
Power - Inlet
PART. NO. DESCRIPTIONITEM NO.
230V 60Hz
27653C
27655C
27652C
27656C
27654C
27657C
Item No. 36
Part No. w/o hole)
FIG. 6
45
46
Glass Filler Shown
for Reference Only
www.DrinkingFountainDoctor.com 800-518-5388