Drinking Fountain Doctor EWHA8 1G Instruction and safety manual

97983C (Rev. B - 8/03)
EWHA8, 14*1G, 2G
PAGE 1
With FLEXI-GUARD®
Installation/Care/Use Manual
USES HFC-134A REFRIGERANT
FIG. 1
34 (SEE FIG. 5)
SEE FIG. 3 7
29
31, 32
14
8 (SEE FIG. 4)
43
26
22, 23, 24,
25, 45, 46
17, 18, 19, 20
44
13
33 (SEE FIG. 6)
30
15, 16
21
27, 41, 42, 47
28

97983C (Rev. B - 8/03)
EWHA8, 14*1G, 2G
PAGE 2
FIG. 2
E = INSURE PROPER VENTILATION BY MAINTAINING 4" (102mm) (MIN.) CLEARANCE FROM CABINET LOUVERS TO WALL.
ASEGURE UNA VENTILACIÓNADECUADA MANTENIENDO UN ESPACIO E 4" (102mm) (MÍN.) DE HOLGURA ENTRE LA REJILLA DE VENTILACIÓN DEL MUEBLE Y LA PARED ASSUREZ-VOUS UNE BONNE VENTILATION EN GARDANT 4" (102mm) (MIN.) ENTRE LES ÉVENTS DE LENCEINTE ET LE MUR.
F = POWER CORD 4 FEET (1219mm) LONG
CABLE ELÉCTRICO DE 4 PIE (1219mm), DE LARGO CORDON DALIMENTATION 4' (1219mm)
G = PLUMBING ROUGH-IN CAN BE LOCATED ANYWHERE WITHIN THIS AREA.
SE PUEDE COLOCAR EL DESBASTE DE LATUBERÍA EN CUALQUIER LUGAR DENTRO DE ESTA ÁREA. ON PEUT PLACER LATUYAUTERIE DANS CETTE RÉGION.
40" (1016mm) RECOMMENDED HEIGHT FOR ADULTS ALTURA RECOMENDADA PARALOS ADULTOS 40" (1016 mm) HAUTEUR RECOMMANDÉE POUR LESADULTES 40" (1016mm)
33" (838mm) RECOMMENDED HEIGHT FOR CHILDREN ALTURA RECOMENDADA PARA LOS NIÑOS 33" (838 mm) HAUTEUR RECOMMANDÉE POUR LES ENFANTS 33" (838mm)
FINISHED FLOOR PISO ACABADO PLANCHER FINI
LEGEND/LEYENDA/LÉGENDE A = RECOMMENDED WATER SUPPLY LOCATION 3/8 O.D. UNPLATED COPPER TUBE CONNECT STUB OUT 1-1/2 IN. (38mm)
FROM WALL SHUT OFF BY OTHERS
SE RECOMIENDA UBICAR ELTUBO CORTO DE CONEXIÓN AL TUBO DE COBRE SIN CHAPAR DE 3/8" DE DIÁM. EXT. A1-1/2"
(38 mm) FUERA DE LA LLAVE DE PASO EN LA PARED COLOCADAPOR TERCEROS.
EMPLACEMENT RECOMMANDÉ D'ALIMENTATION EN EAU PAR TUBE EN CUIVRE NON PLAQUÉ DE 3/8 PO. (9,5 mm) D.E.
CONNECTANT UNE TUYAUTERIE DE 1-1/2 PO. (38 mm) DEPUIS LE ROBINET D'ARRÊT FOURNI PAR D'AUTRES.
B = RECOMMENDED LOCATION FOR WASTE OUTLET 1-1/4 O.D. DRAIN
UBICACIÓN RECOMENDADA PARA EL DRENAJE DE SALIDA DE AGUA, DE 1¼ DE DIÁMETRO. EMPLACEMENT RECOMMANDÉ POUR LE DRAIN DE D.E. 1-1/4" DE SORTIE DEAU.
C = 1-1/4 TRAP NOT FURNISHED
PURGADOR DE 1¼ NO PROPORCIONADO SIPHON 1-1/4 NON FOURNI
D = ELECTRICAL OUTLET LOCATION
UBICACIÓN DE LA TOMA DE ELECTRICIDAD EMPLACEMENT DE LA PRISE DE COURANT

97983C (Rev. B - 8/03)
EWHA8, 14*1G, 2G
PAGE 3
Stream height is factory set at 35 PSI. If supply pressure varies
greatly from this, remove Items 1 & 2 and adjust screw on
Item 4. Clockwise adjustment will raise stream and counter-
clockwise adjustment will lower stream. For best adjustment,
stream should hit basin approximately 6-1/2" (165mm) from
bubbler.
BASIN
FIG. 3
NOTE:
WHEN INSTALLING REPLACEMENT
BUBBLER AND PEDESTAL, TIGHTEN
NUT (ITEM 12) ONLY TO HOLD
PARTS SNUG IN POSITION.
DO NOT OVER TIGHTEN.
FIG. 4
BASIN
9
10
11
12
8
4
3
1
5
6
2
WIRING DIAGRAM
This Drawing is merely for illustrating the
components of the electrical system.
A54731
A54732
70793C
A54729
30511C
50226C
28365C
70606C
70302C
70836C
28366C
28367C
1
2
3
4
5
6
7
8
9
10
NS
PART. NO. DESCRIPTIONITEM NO.
HOT TANK PARTS LIST
Hot Tank Weldment Assy. 115V
Hot Tank Weldment Assy. 220V
1/4 Elbow
Thermostat
Hot Control
Hot Control Insulator
Thermostat Bracket
Drain Plug
Screw #6-32 x 3/16" PHTC
3/8 x 1/4 Elbow
Hot Tank Mounting Bracket
Hot Tank Assy. Mntg. Bracket
FIG. 5
35 36
38
40
37
39
HOT TANK ASSEMBLY
3
6
7
9
1
2
8
4
5
10
7
FIG. 6

97983C (Rev. B - 8/03)
EWHA8, 14*1G, 2G
PAGE 4
PRINTED IN U.S.A.
PARTS LIST 115V
ITEM NO. PART NO. DESCRIPTION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
*22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
NS
Cover
Button
Regulator Retaining Nut
Regulator
Hex Nut
Regulator Holder
Basin
Basin (GF)
Bubbler Assy
Orifice Assy
Housing Assy
Pedestal
Bubbler Locknut
Cold Control
Power Cord
Condenser (8 GPH)
Condenser (14 GPH)
Fan Shroud
Fan Motor (8 GPH)
Fan Motor (14 GPH)
Fan Blade
Fan Bracket
Fan Blade Nut
Drier (8 GPH)
Drier (14 GPH)
Compressor Serv. Pak 8 GPH
Compressor Serv. Pak 14 GPH
Overload (8 GPH)
Overload (14 GPH)
Relay Cover (8 & 14 GPH)
Electrical Shield
Strainer
Tailpipe/Vacuum Break
Poly Tubing (Cut To Length)
Heat Exchanger (8 GPH)
Heat Exchanger (14 GPH)
Evaporator (8 GPH)
Evaporator (14 GPH)
Hot Tank Switch Bracket
Hot Tank Switch
Hot Tank Assy
Hot Valve Assy
Gooseneck
Hot Valve Kit
Handle
Shroud
Mounting Nut
Body Gasket
Receptor-Drain
Clamp-Hose
Tee - 1/4 x 1/4 x 1/4
Union - 1/4
Relay (14 GPH)
Relay (8 GPH)
Capacitor (14 GPH)
Gasket - Drain
Gasket (GF)
Nipple - Bubbler (GF)
Flow Regulator Assy
40089C
40048C
15005C
61313C
40169C
50986C
21541C
21539C
56073C
40322C
56011C
55997C
75580C
31513C
36132C
66417C
66432C
21516C
36144C
31491C
30664C
27681C
70018C
66202C
66203C
35762C
35775C
36196C
35840C
35768C
194243901550
55996C
45448C
56092C
66229C
66445C
66505C
66506C
28427C
36101C
36154C
45786C
40597C
92712C
51543C
40596C
70921C
33659000
50368C
70750C
70682C
70683C
35843C
36181C
35844C
50005C
100322740560
15009C
55832C
RIGHT PANEL
(w/o hole) FRONT PANEL
LEFT PANEL
COLOR TABLE
Gray Beige
Almond
Stainless Steel
Sandalwood
Granite
Light Gray Granite
20638C
21464C
20640C
21462C
27171C
27172C
21526C
21530C
21527C
21528C
27192C
N/A
20675C
20676C
20672C
21454C
27150C
21455C
*INCLUDES RELAY & OVERLOAD. IF UNDER WARRANTY, REPLACE
WITH SAME COMPRESSOR USED IN ORIGINALASSEMBLY.
NOTE: All correspondence pertaining to any of the above water
coolers or orders for repair parts MUST include Model No. and Serial
No. of cooler, name and part number of replacement part.
36131C
31430C
35789C
35764C
36168C
31028C
35768C
66452C
36155C
36164C
35826C
14
17
22*
23
24
29
33
45
-
Power Cord (8 & 14 GPH)
Fan Motor (8 & 14 GPH)
Compressor Serv. Pak (8 GPH)
Compressor Serv. Pak (14 GPH)
Overload (8 GPH)
Overload/Relay Assy. (14 GPH)
Relay Cover (8 & 14 GPH)
Heat Exchanger (8 GPH)
Hot Tank Assy (8 & 14 GPH)
Relay (8 GPH)
Power Inlet
PART. NO. DESCRIPTIONITEM NO.
230V 50/60 Hz
RIGHT PANEL
(w/ hole)
20639C
21465C
20641C
21463C
27174C
27175C
Glass Filler Shown
for Reference Only
48
49
FIG. 7
www.DrinkingFountainDoctor.com 800-518-5388