Drivecon PWR Installation manual

820 Lakeside Drive 

Gurnee, IL 60031-9165 

Ph: [phone] 

Fax: [phone]
www.drivecon.com 

E-mail: [e-mail] 

[phone]
V:\Production\Radios\PWR\Transmitter programming instructions
PWR RADIO TRANSMITTER
PROGRAMMING INSTRUCTIONS
1. With power disconnected from the receiver, open cover
by loosening the two cover fastening screws and remove
the Eeprom by pulling up as shown.
2. To prevent damage to the transmitter upon
reassembly, turn the key-lock to the 0 or OFF position.
Next remove the cover fastening screws from the bottom.
3. Install the battery and insert Eeprom with the spade
connector to the outside into the programming pin
connector.
4. Depress and hold the ON/OFF micro-switch.

5. Next while holding the ON/OFF micro-switch press and
release the two E-stop micro-switches. The transmitter’s
green LED will turn ON and then it will start flashing
orange (green and red LEDs flashing). If it does not,
repeat steps 3-5. Wait for the LED to stop flashing.
The transmitter is now programmed!
6. Return the Eeprom to the receiver, close the cover
and reassemble the transmitter. Make sure the keylock is
still in the 0 or OFF position as damage to the ON/OFF
micro-switch will result if cover is put back on with it
in the On position!