DSPPA MAG6388 User manual

[email protected] /www.dsppatech.com The specifications will be subject to change without prior notice.
Copyright © Guangzhou DSPPA Audio Co.,Ltd All rights reserved.
MAG6388 120W Network Column Speaker
The .MAG6388 network column speaker is a network all-digital analog-digital conversion signal processor
with high-fidelity speaker based on TCP/IP transmission protocol. The modern network play terminal can be
mounted to any place with access to network. The machine can output the remote audio data stream as the
audio signal and give a sound directly, with intelligent control of the host.
Adopt all-weather design and waterproof unit, applicable to indoors and outdoors, with long service
life, high sensitivity (92±2dB), and clear and bright sound.
Maximum sound pressure level of 108±2dB, and effective frequency range of 80Hz ~ 16kHz.
Can be mounted to any place with access to network.
Support 16bit digital audio stream decoding at a maximum sampling rate of 48kHz.
Built-in 1×120W digital amplifier, with low power consumption.
Can play background music, emergency paging and alarm signals from the system host.
Adopt aluminum mesh, no rust.
Two-way structure, wider frequency band.
With waterproof structure, waterproof grade IPX6.
Model
MAG6388
Acoustic System
Driver Unit
8＂×2,1＂×1
Sensitivity(1m,1W)
92±2dB
Max.SPL(1m)
108±2dB
Freq. Resp.
80Hz-16kHz(±3dB)
Description
Features
Specifications

[email protected] /www.dsppatech.com The specifications will be subject to change without prior notice.
Copyright © Guangzhou DSPPA Audio Co.,Ltd All rights reserved.
Rated Power (RMS)
120W
NET Play
Freq. Resp.
50Hz-16kHz(±3dB)
Distortion
≤0.5%
SNR
≥70dB
Power Supply
AC220V/50Hz
Package Dimension (L×W×H mm)
285×315×775
Machine Dimension (H×W×L mm)
230×250×665
Gross Weight
15.7kg
Net Weight
12.2kg
Product Information
1. Network interface
Connected to the network cable.
2. AC220V power input
3. Mounting hole
Installation Diagram
MAG6388: 66cm
Installation Method
1. Select an appropriate position to install six M8 expansion bolts on a vertical surface where the column
speaker needs to be installed, and then mount the brackets and fix it, as shown above.
2. Connect the power cable and network cable.
3. Adjust the speaker angle and check whether it is secure and stable.