Dualit DUAL TOASTER 2 AND 4 SLOT MODELS Product information sheet

GUARANTEE AND
INSTRUCTIONS FOR
THE DUALIT TOASTER
2 AND 4 SLOT MODELS
Dualit Toaster large printV2 22/1/04 10:41 am Page 1 Studio1 Studio1:Desktop Folder:

1
Thank you for purchasing Dualit toaster. Please read
this instruction manual thoroughly and carefully
before you start operating the unit to ensure safe
and reliable performance.
IMPORTANT SAFEGUARDS
READ ALL INSTRUCTIONS CAREFULLY
BEFORE USING THE TOASTER.
•Before plugging in, check that the voltage on the
rating label is the same as the mains supply.
•To protect against electric shock, do not immerse
any part of this product in water or other liquid.
•Position the appliance in such a way that:
- the mains cord does not hang over the edge
of the table or worktop;
- it is standing on a flat surface with sufficient
free space around it;
- it is out of the reach of children.
•Unplug from outlet when not in use and before cleaning.
Allow to cool before putting on or taking off parts.
•Do not operate the appliance with a damaged
cord or plug. Do not allow cord to touch hot surfaces,
or to hang over edge of a table or counter.
•Do not place on or near a hot gas or electric burner,
or in a heated oven.
•Do not attempt to dislodge bread when the toaster
is plugged in.
• When in use a fire may occur if the toaster
is covered or touching flammable material.
Bread may burn. Therefore toasters must
not be used near or below curtains, kitchen
cupboards and other combustible materials.
• This is an attended appliance. Do not leave
working appliance unattended.
SAFETY INFORMATION
Dualit Toaster large printV2 22/1/04 10:41 am Page 2 Studio1 Studio1:Desktop Folder:

2
•This appliance is not intended for use by young
children or infirm persons without supervision.
•The use of accessory attachments other than those
sold by Dualit Ltd are not recommended as this
may cause hazards.
•Do not use outdoors.
•With continuous use parts of the toaster may
get hot.
•Clean out accumulated crumbs frequently to avoid
the risk of fire or malfunctioning of the toaster.
•Do not insert foil-covered or oversized foods into
the toaster.
•NOTE: Any plug cut from power supply cord
should be disposed of immediately. Inserting any
cut off plug into a 13A socket-outlet is hazardous.
•Never use the plug without the fuse cover fitted.
Ensure replacement fuse is the same current value
as original. Replacement fuses are available from
Dualit Ltd and should be ASTA approved to BS1362.
•Use this appliance only for its intended purpose
as described in this manual.
•Connect the appliance to an earthed wall socket.
•Do not use foods with coatings or fillings that may
start to drip when heated up.
•Never leave the appliance unattended when in use.
•Avoid touching the slots of the toaster, as they
become very hot.
•Do not put your fingers in the slots of the toaster.
•Never insert sharp or abrasive objects into the slots,
as this will cause damage.
Dualit Toaster large printV2 22/1/04 10:41 am Page 3 Studio1 Studio1:Desktop Folder:

3
Caution: Do not wrap the mains cord around the body
of the toaster during or after use. The cord storage
facility is located on the underside of the toaster.
•Unpack the toaster from all packaging and
remove any stickers. Wipe the outside of the
toaster using a moist cloth. Dry thoroughly.
•Make sure the toaster lever is in the raised
position when you put the plug in the wall socket.
•Set the toaster control to 8, the highest toasting
setting and press the toaster toasting lever down
until it engages.
The red light will glow to show that the toaster
is heating. Toast lever will only engage
when the toaster is plugged in with power on.
Let the toasting complete the first cycle without
slices of bread in it to condition the elements for use.
Most heating appliances produce an odour
and/or smoke when used for the first time.
This is normal.
•Plug the toaster into the wall power socket and
turn power ‘ON’ at socket.
•The toaster will only engage when it is plugged
in and the power switched ‘ON’.
•To toast, set the desired browning setting by
means of the Electronic Browning Control
(1is the lightest and 8is the darkest setting).
The required setting depends on the thickness
of bread and type of bread being toasted.
•After having selected the desired browning setting,
place the bread into the slots and press the toasting
lever down until it engages. The red light will glow
for the duration of the toasting cycle.
USING THE APPLIANCE
BEFORE YOU START USING THE APPLIANCE
Dualit Toaster large printV2 22/1/04 10:41 am Page 4 Studio1 Studio1:Desktop Folder:

•When the toasting cycle is complete the slices will
pop up automatically and are ready for removal
from the slots. If the slices are difficult to remove
safely, you can lift the lever upwards for extra high lift.
•To immediately stop toasting at any time, lift the toast
lever up lightly.
•Remove the plug from outlet.
•Slice bagel into two equal halves before toasting.
Insert bagel so both ‘cut’ sides are facing inwards
to centre element.
•Select the desired browning setting.
•Press the toasting lever down until it engages and
the red light illuminates.
4
•As soon as the bagel is lowered, immediately
press the Bagel button, located on the end of the
browning selector the red light will now flash.
•Pressing this button reduces the heat produced
from the outer elements gently warming the
outside of the bun while still toasting the inside of
the bagel to perfection.
•The red light will flash to indicate that the Bagel
feature is working.
•To toast frozen bread increase usual browning
setting by 0.5 to 1.
THE BAGEL FEATURE
FROZEN BREAD
Dualit Toaster large printV2 22/1/04 10:41 am Page 5 Studio1 Studio1:Desktop Folder: