5
Installation and Operation of MUHC
Electrical LOCKOUT/TAGOUT Procedure. Disconnect all circuits. Failure to comply
with this procedure can cause property damage, injury or death.
: Before removing any access panels or servicing this equipment,
always perform the Electrical LOCKOUT/TAGOUT Procedure. Be sure all circuits are
disconnected. Failure to comply with this procedure can cause property damage,
injury or death.
: Do not operate this equipment without properly placing and securing
all covers and access panels. Failure to comply with this procedure can cause
property damage, injury or death.
: For your safety, do not use or store gasoline or other ammable
vapors or liquids in the vicinity of this or any other appliance. Failure to comply
can cause property damage, injury or death.
: In the event of a power failure, do not attempt to operate this
appliance. Failure to comply can cause property damage, injury or death.
: This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities, or lack of experience
and knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety. Children should be
supervised to ensure they do not play with the appliance.
CAUTION
Observe the following:
• Minimum clearances must be maintained from all walls and combustible materials.
• Keep the equipment area free and clear of combustible material.
• Maintain adequate clearance for air openings.
• Operate equipment only on the type of electricity indicated on the data sticker.
• Retain this manual for future reference.
INTRODUCTION
The Duke MUHC was developed for extended food-
holding capabilities to provide consistently high, “just
cooked” food quality.
The MUHC utilizes Duke’s patented “heat sink” holding
technology that provides even heat distribution to food
pans through the bottom and sides. This allows pre-
cooked foods to be held for extended periods without
noticeable degradation of quality, reducing food scrap/
waste.
The self contained, individually formed, sealed
compartments of the MUHC eliminates food odor and
taste transfer. Because the compartments are sealed
and feature fully radiused corners, no disassembly is
required for cleaning or product changes.
The unique design of the MUHC allows multiple
temperature operation for all existing product groups.
SERIAL NUMBER LOCATION
The Serial Number Data Label is located on the
rear of the unit, above the power cord connection.
Refer to the Serial Number Data Label for proper
electrical requirements. The serial number and
model number are required when communicating
with the Duke Service Dept.
