Dunlop JERRY CANTRELL FIREFLY CRY BABY JC95FFS User manual

JERRY CANTRELL FIREFLY CRY BABY®WAH
JC95FFS

JC95FFS JERRY CANTRELL FIREFLY CRY BABY®WAH 2
1 FINE TUNE knob adjusts tone of toe-down rocker position
EXTERNAL CONTROLS
1

JC95FFS JERRY CANTRELL FIREFLY CRY BABY®WAH 3
BASIC OPERATION
POWER
The Jerry Cantrell Cry Baby®Wah is powered by one 9-volt battery
(accessed via underside of pedal), the Dunlop ECB003 9-volt
adapter, or an MXR® Brick™Series power supply.
OPERATION
1. Run a cable from your guitar to JCB95FFS’ INSTRUMENT jack
and run another cable from the JC95FFS’ AMPLIFIER jack to your
amplifier.
2. Push the toe of the pedal down until you feel a “click” to turn
the pedal on/off.
3. Rotate the FINE TUNE knob clockwise for a brighter toe-down
response or counterclockwise for a darker toe-down response.
4. Rock your foot back and forth on the pedal to hear the vocal,
expressive tones that the Cry Baby Wah is famous for.

JC95FFS JERRY CANTRELL FIREFLY CRY BABY®WAH 4
SPECIFICATIONS
Input Impedance 1MΩ
Output Impedance 10KΩ
* VREF=1VRMS, A-weighted
IMPEDANCE
Heel Down 310 Hz ~ 410 Hz
Toe Down Fine Tune Max 1700 Hz to 2070 Hz
Toe Down Fine Tune Min 1050 kHz to 1270 Hz
FILTER CENTER FREQUENCY
Input -11.5 dBV
Output +6 dBV
Heel Down +18 dBV
Toe Down +20 dBV
Heel Down >97 dB
Toe Down >89 dB
MAXIMUM LEVEL
MAXIMUM GAIN AT CENTER FREQUENCY
NOISE FLOOR*
Bypass Hardwire
Current Draw 1 mA
Power Supply DC 9 volts