DuraComm LP-14N User manual

1
!
!
LP#14N'
Desktop'Power'Supply'
Owners'Guide'
(These instructions are intended for use by a technician familiar with electronic products)
•Filtered!and!regulated!
•Redundant!temperature!protection!
•Overload!protection!
•Over!voltage!protection!
•UL!Recognized!
•ISO!9001!
•3!year!warranty!
DESCRIPTION
The DuraComm LP Series of power supplies are UL recognized. They are manufactured in accordance with ISO 9001 quality
assurance standards. These power supplies convert 120 or 240 volt 50/60 Hz AC power to low noise and ripple, regulated 13.8 volt DC
output. (Note: units are factory pre-set for 120 AC input. Conversion for 240 volt AC input requires an internal adjustment by removing a
“jumper wire” on the circuit board. This should only be done by a qualified technician or should be specified at the time of purchase.)
DuraComm’s power supplies are protected against inadvertent shorts and overloads by an electronic output current limiting
circuit. This current limiting circuit reduces the output limiting to a very low and safe value until the overload is removed from the power
supply. As soon as the overload is removed, the output will be automatically restored.
Additionally the power supplies incorporate an over temperature feature to protect against undesired component failure should
operation in excessive environmental temperatures occur. Units exceeding 15 amps surge output are equipped with cooling fans.
When these supplies (Model LP-18 and LP-25) are lightly loaded and cool, the fan will not run. When demand on the power
supply increases and the internal temperature reaches 40°C, the fan will begin to run until the temperature drops below this threshold.
DuraComm LP series power supplies are compatible with all LPH radio hoods.
DuraComm LP series power supplies may be configured for battery back up & charging applications with the addition of the LPBC-25.
See www.duracomm.com for more information.
SPECIFICATIONS
AC Input Voltage .............................................................................100 ~ 130 VAC (pre-set), 200 ~260 VAC (take off internal jumpter J7)
Output Voltage ..............................................................................................................................13.8 VDC (pre-set_ 12-15V Adj By. VR1)
Output Ripple....................................................................................................................................................... 150 mV or less @ full load
Current at 20C ...................................................................................................................................................................... Surge 14 Amps
Continuous amps.............................................................................................................................................................................11 Amps
Duty Cycle .....................................................................................................................................................................Continuous = 100%
Overload ..................................................................................................................................Fold back limited @ 120% maximum output
Over Voltage .............................................................................................................................................................. 16.5 VDC, auto re-set
Over Temperature ....................................................................................................................... Typical internal sensor point 70C (156 F)
Load Regulation...................................................................................................................................................... 0.5% No load to full load

2
Line Regulation............................................................................................................................................... 0.1% Max from 115-130 VAC
Efficiency .....................................................................................................................................................................................80% typical
Cooling...................................................................................................................................................................................... Convectional
Dimensions (all units) .............................................................................192mm L x 178mm W x 45.5 mm H 7-5/8” L x 7” W x 1-13/16” H
Enclosure.................................................................................................................................................................................. Steal, vented
Power Cable ...............................................................................................................................3 wire grounded with CEE input connector
Output Terminals ..................................................................................................................................................................... Binding Posts
Quality Assurance ......................................................................................................................................................... ISO 9001 standards
Safety ................................................................................................................................................................................... UL Recognized
WARNING:
The individual user should take care to determine prior to use or installation whether this device is suitable, adequate, or safe for the
use intended. Since individual applications are subject to great variation, DuraComm makes no representation or warranty as to the
merchantability, suitability or fitness of these units for any specific application.
Precision regulated power supplies operate internally from voltages in excess of 300 volts. In rare cases, voltage spikes or
transients on the AC power line, or over heating, may cause a component failure in the power supply. If this failure results in over
voltage at the output terminals, the electronic over voltage feature will operate. Overload of the output will cause the over current
feature to operate. In either case, the cause must be determined and corrected.
Failures require investigation as to the cause and/ or repair of the unit. THIS UNIT DOES NOT HAVE ANY USER SERVICEABLE
PARTS. SERVICE AND REPAIR MUST BE REFERRED TO QUALIFIED PERSONNEL.
OPERATION:
Connect your 12 volt DC device to the red (positive) and black (negative) binding posts. Be certain you connect positive to positive (red)
and negative to negative (black). Insert the AC plug into an AC outlet of the proper voltage.
Press the ON/OFF switch to the ON position and observe that the indicator light illuminates. If the indicator light fails to light,
recheck the equipment installation, hook-up polarity, and the AC outlet.
PRECAUTIONS: DO NOT block any openings in the case or operate the unit in a hot, enclosed environment or compartment. Be sure
adequate ventilation is provided since heat build-up will shorten component life. NOTE: Most audio and radio equipment draws much
less average current than the peak demand.
If the unit stops working, check the 12 volt connections for tightness. If the unit fails again or repeatedly, have the unit checked
by a qualified technician. HAZARDOUS VOLTAGES EXIST INSIDE THE UNIT. THERE ARE NO USER SERVICEABLE PARTS
INSIDE. DO NOT EXPOSE THE UNIT TO RAIN OR MOISTURE.
Warning: The DuraComm series of desk top power supplies are accurately regulated to maintain output voltage from no load to full
load. Slightly above the rated output load, the current limiting circuit begins to act, reducing the output voltage to prevent unit overload
damage. Some loads, like incandescent lamps will have start-up current loads that are up to ten times the normal “hot” current drain. To
ensure the DuraComm power supply will not encounter current limiting shut down; only operate incandescent loads that are about one-
half to two-thirds of the maximum current rating.
NOTE: This device complies with part 15 of the FCC rules. Operation is subject to the following 2 conditions; 1) This device may not
cause harmful interference, and 2) This device must accept any interference received, including interference that may cause undesired
operation.
!
!
!
!

3
CONDUCTOR PRETREATMENT
All kinds of copper conductors can be clamped without treatment. DO NOT solder tin stranded conductors. The solder yields and
fractures under high pressure. The result is increased contact resistance and excessive temperature rise. Additionally, corrosion has
been observed due to the fluxes. Notch fractures at the transition from the rigid tinned part to the flexible conductors are also possible.
Ferrules can be used as a protection when wiring stranded conductors. Copper ferrules prevent the current transfer from being
influenced by dissimilar metals and remove the risk of corrosion. Always use the correct tool to crimp the ferrule.
RECOMMENDED COPPER WIRE SIZE FOR CURRENT CAPACITY
(Insulated Wire, Single Conductor in free air)
Current Level in Amperes
<7 AMPERES
Wire Size
20 AWG Up to 5 feet
18 AWG Up to 10 feet
14 AMPERES
18 AWG Up to 5 feet
16 AWG Up to 10 feet
20 AMPERES
16 AWG Up to 5 feet
14 AWG Up to 10 feet
30 AMPERES
14 AWG Up to 5 feet
12 AWG Up to 10 feet
40 AMPERES
12 AWG Up to 5 feet
10 AWG Up to 10 feet
50 AMPERES
10 AWG Up to 5 feet
8 AWG Up to 10 feet
70 AMPERES
8 AWG Up to 5 feet
6 AWG Up to 10 feet
100 AMPERES
6 AWG Up to 5 feet
4 AWG Up to 10 feet

4
LIMITED WARRANTY
DuraComm warrants to the initial end user, each power supply manufactured by DuraComm to be free from defects in
material and workmanship, when in normal use and service for a period of three years from the date of purchase, from an
authorized DuraComm dealer.
Should a product manufactured by DuraComm fail or malfunction due to manufacturing defect, or faulty component,
DuraComm, at its option, will repair or replace the faulty product or parts thereof, which, after examination by
DuraComm, prove to be defective or not operational according to specifications in effect at the time of sale to the initial
end user. The product that is replaced or repaired under the provisions of this warranty, will be warranted for the
remainder of the original warranty period, only, and will not extend into a new three year warranty period.
The limited warranty does not extend to any DuraComm product which has been subject to misuse, accidental damage,
neglect, incorrect wiring not associated with manufacture, improper charging voltages, or any product which has had the
serial number removed, altered, defaced, or changed in any way.
DuraComm reserves the right to change, alter, or improve the specifications of its products at any time, and by so doing,
incurs no obligation to install or retrofit any such changes or improvements in or on products manufactured prior to
inclusion of such changes.
DuraComm requires any product needing in or out of warranty service to be returned to DuraComm. All requests for
warranty service must be accompanied by proof of purchase, such as bill of sale with purchase date identified. DuraComm
is not responsible for any expenses or payments incurred for the removal of the product from its place of use,
transportation or shipping expenses to the place of repair, or return expenses of a repaired or replacement product to its
place of use.
The implied warranties which the law imposes on the sale of this product are expressly LIMITED, in duration, to the three
(3) year time period specified herein. DuraComm will not be liable for damages, consequential or otherwise, resulting from
the use and operation of this product, or from the breach of this LIMITED WARRANTY.
Some states do not allow limitations on the duration of the implied warranty or exclusions or limitations of incidental or
consequential damages, so said limitations or exclusions may not apply to you. This warranty gives you specific legal
rights which vary from state to state.
This warranty is given in lieu of all other warranties, whether expressed, implied, or by law. All other warranties,
including WITHOUT LIMITATION, warranties of merchantability and fitness or suitability for a particular purpose, are
specifically excluded. DuraComm reserves the right to change or modify its warranty and service programs without prior
notice.
DuraComm® Corporation
6655 Troost Avenue
Kansas City, MO 64131
Phone [phone] Fax [phone]
www.duracomm.com
Version 0429-14