DUTSCHER MagnetaPure 32 Plus User manual

MagnetaPure 32 Plus Nucleic Acid Purification System
1
Quick Start Guide For MagnetaPure 32 Plus
This is a short protocol and does not replace the original manual. Carefully
read the whole manual and safety instructions prior to operation!
Remove the transport lock before switching on the device! Do NOT power
the instrument on prior to removing the transport lock.
Always ensure that the local supply voltage in the laboratory
conforms to that specified on the type label on the back of the
instrument. Do not connect from ungrounded power sockets.
1. Preparation
Remove the instrument from the packing case, Remove the tape around the cabin door, open the
door. Remove the two screws by hand as shown in the figure below and remove the red transport
fixing block to release the moving parts.
In the process of dismantling, please be careful not to collide with magnetic
rods, otherwise it will damage the magnetic rod!
Do NOT power the instrument on prior to removing the transport lock.
2. Connect the power
Connect one end of power cord to the instrument socket and the other to power (AC100~240V),
then turn on the power switch.
Screw
Transport fixing block
DOMINIQUE DUTSCHER SAS

MagnetaPure 32 Plus Nucleic Acid Purification System
2
3. Plate installation
Prepare the plates according to the manufacturer’s protocol instructions. Open the cabin door and place
the appropriately prepared 96-well plates with the sample in the locating slot according to the arrow. Pay
attention to the orientation of the plate: Place the A1 well of the plate so that it is in the upper left
corner.
4. Install the magnetic rod cover
Insert the tip combs into the slots on the mounting groove of the tip comb holder according to the arrow.
Ensure the tip combs are fully insertes as it may damage the magneti rods if installation is incorrect.
Never operate the MagnetaPure 32 Plus without the mangetic rods being covered with the tip combs.
5. Operation
For details on operation, setting and operation, please refer to the operating instructions.
96-Deep well plate
Magnetic rod’s tip
DOMINIQUE DUTSCHER SAS