DV8 TCGL-01 User manual

TCGL-01
Jeep Gladiator JT
In-Bed Adjustable Tire Carrier

2
1. Begin by opening all packaged items and inspecting them for damage or missing items. Contact the
company you purchased the item from if there are any concerns.
2. Once all items are opened, remove the front rail for the Trail Rail Management System if applicable.
3. Attached the header board loosely with the supplied hardware as shown in the image.

3
4. Install the lower support. The lower support has two holes on each side. The front hole with the
factory threaded hole in the bed is required, the second hole that is through bolted is optional for
tires larger than 40”.
5. Once both support bars are installed, place the passenger side mount into place as show and loosely
install hardware. This needs to be able to move to get the main carrier and driver side mount
installed.

4
6. Install the main carrier onto the passenger side mount by slipping the main tube over the passenger
mount tube. Then place the driver side mount into the main carrier tube and place it on the bed
mounts and secure into place.
7. Tighten all hardware at this point. Main carrier tube should easily move up and down. Next, secure
bolt pull locks into place using provided hardware. Make sure to put pull lock into one of two holes
on main center tube before securing. NOTE: These may need to be tapped into placed initially. This
is normal.

5
8. With the carrier locked in the up position, install the two gas shocks as shown. These are very heavy
shocks that cannot be compressed by hand.
9. Lastly install the tire mount as shown. Once secured, you can install you wheel and tire combination.

6
10. Install the tire faced up on the post. Then place the rubber cone, round plate, and finally the screw
handle.
NOTE: For 0+ offset wheels or 13.50”+ tires, you may need to flip over the tire and wheel to allow
for proper fitment.
If you have any questions, please email [e-mail] or call 951-
680-9595.