DVDO C3-1 User manual

Version: V1.0.1
DVDO-C3-1
PTZ Auto Tracking Camera
User Manual

DVDO-C3-1 PTZ Auto Tracking Camera User Manual DVDO
Important Safety Instructions
1. Do not expose this apparatus
to rain, moisture, dripping or
splashing, and do not place
objects filled with liquids, such as
vases, on the apparatus.
6. Clean this apparatus
only with dry cloth.
2. Do not install or place this unit
in a bookcase, built-in cabinet or
in any confined space. Ensure the
unit is well ventilated.
3. To prevent risk of electric
shock or fire hazard due to
overheating, do not obstruct
the unit’s ventilation openings
with newspapers, tablecloths,
curtains, and similar items.
4. Do not install near any heat
sources such as radiators, heat
registers, stoves, or other
apparatus (including amplifiers)
that produce heat.
5. Do not place sources of naked
flames, such as lighted candles,
on the unit.
7. Unplug this apparatus
during lightning storms or
when unused for long
periods of time.
8. Protect the power cord
from being walked on or
pinched, especially at the
plug.
9. Only use attachments /
accessories specified by
the manufacturer.
10. Refer all servicing to
qualified service
personnel.

DVDO DVDO-C3-1 PTZ Auto Tracking Camera User Manual
1
FCC Warning
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.

DVDO-C3-1 PTZ Auto Tracking Camera User Manual DVDO
Table of Contents
Introduction ...................................................................................................... 2
Features ................................................................................................... 2
Package Contents .................................................................................... 3
Specifications ........................................................................................... 4
Panel Description ..................................................................................... 7
Dimensions............................................................................................... 8
Installation and Wiring ..................................................................................... 9
Installation ................................................................................................ 9
Wiring ....................................................... Error! Bookmark not defined.
IR Remote Control ......................................................................................... 12
RS232 Control ................................................. Error! Bookmark not defined.
RS232 Interface...................................................................................... 16
VISCA Network....................................................................................... 18
RS232 Serial Communication Control .................................................... 18
GUI Settings .................................................................................................. 19
MENU ..................................................................................................... 19
EXPOSURE............................................................................................ 20
COLOR................................................................................................... 21
IMAGE .................................................................................................... 22
P/T/Z....................................................................................................... 23
NOISE REDUCTION .............................................................................. 23
SETUP.................................................................................................... 25
COMMUNICATION SETUP .................................................................... 25
RESTORE DEFAULT ............................................................................. 26
Network Function........................................................................................... 27
Operating Environment............................. Error! Bookmark not defined.
Equipment Installation ............................................................................ 27

DVDO DVDO-C3-1 PTZ Auto Tracking Camera User Manual
3
Internet Connection ................................................................................ 27
Camera Controlled by LAN..................................................................... 28
Setup IP Address............................................................................. 28
Visit/Access Camera ....................................................................... 30
Camera Controlled by WAN.................................................................... 31
Setup IP Controlled by Dynamic DNS ............................................. 31
Dynamic DNS Visit Camera............................................................. 32
VLC Stream Media Player Monitor .................................................. 32
Camera Parameter Setup....................................................................... 34
Homepage Introduction ..................... Error! Bookmark not defined.
Video Settings ................................................................................. 37
Image Settings................................................................................. 39
Audio Settings ................................................................................. 40
System Settings............................................................................... 40
Network Settings ............................................................................. 41
Device Information........................................................................... 42
Download the Upgrade Program .............. Error! Bookmark not defined.
Troubleshooting ............................................................................................. 43
Warranty Terms and Conditions..................................................................... 44

Introduction
Features
Integrated Design: Provides panoramic and close-up 4 channel Full HD
1080p video.
Intelligent Tracking for Education: Built-in image recognition and tracking
algorithm smoothly tracks the subject without auxiliary positioning
camera or tracking host. Multiple cameras can be installed to track
teacher and/or students.
Replaceable Lens: The panoramic lens is replaceable and compatible
with M12 interface lenses, making it easy to adapt to different classroom
scenarios.
Adjustable Viewing Angle: The panoramic lens angle can be adjusted up
and down (-15°~0°) to facilitate installation and adjustment.
Consistent Video: The panoramic and close-up images provide
consistent brightness and color.
72.5° Wide-Angle Lens: Close-up camera uses 72.5° wide-angle
high-quality lens and supports 12x optical zoom and 16x digital zoom.
Full HD 1080p: High-precision Panasonic HD CMOS 1/2.7” sensor
provides 2.07 million effective pixels, reaching 1920 x 1080 maximum
resolution with pristine image quality.
Ultra-High Frame Rate: Provides clear, smooth 1080p video in 60fps.
AAC Audio Encoding: Close-up camera supporte AAC audio encoding
for superior sound quality and reduced bandwidth requirement.
Low Light Performance: 2D / 3D noise reduction algorithms greatly
reduce image noise to keep images clean and clear even under ultra-low
lighting, with signal-to-noise ratio up to 55dB.
Remote Control: The camera can be controlled remotely through the
RS232 serial port.

Package Contents
1 x USB Camera
1 x AC Power Adaptor
1 x Power Cable
1 x RS232 Cable
1 x Remote
1 x Wall Bracket with Screw Pack

Specifications
Camera
Video System 1080p/60, 1080p/50, 1080i/60, 1080i/50, 1080p/30,
1080p/25, 720p/60, 720p/50
Sensor 1/2.7'', CMOS, Effective Pixel: 2.07M
Scanning Mode Progressive
Lens 12x, f=3.5mm ~ 42.3mm, F1.8 ~ F2.8
Teac her Panorama
Lens f=6mm, F1.8, angle of view ~60° (optional)
Student Panorama
Lens f=3.24mm, F1.8, angle of view ~84° (optional)
Digital Zoom 16x
Minimum Illumination 0.5 Lux @ (F1.8, AGC ON)
Shutter 1/30s ~ 1/10000s
White Balance Auto, Indoor, Outdoor, One Push, Manual, VAR
Backlight
Compensation Supported
Digital Noise Reduction 2D & 3D Digital Noise Reduction
Signal Noise Ratio ≥55Db
Horizontal Angle of
View 72.5° ~ 6.9°
Vertical Angle of View 44.8° ~ 3.9°
Horizontal Rotation
Range ±170°
Vertical Rotation
Range -30° ~ +90°
Pan Speed Range 1.7° ~ 100°/s
Tilt Speed Range 1.7° ~ 69.9°/s

H & V Flip Supported
Image Freeze Supported
Number of Preset 255
Preset Accuracy 0.1°
Network Features
Video Compression H.264/MJPEG
Video Stream First Stream, Second Stream, Third Stream, Fourth
Stream
First Stream Resolution 1920x1080, 1280x720, 1024x576, 960x540,
640x480, 640x360
Second Stream
Resolution
1920x1080, 1280x720, 1024x576, 720x576 (50Hz
support), 720x480 (60Hz), 720x408, 640x360,
480x270, 320x240, 320x180
Third Stream
Resolution
1024x576, 960x540, 720x576 (50Hz),
720x480 (60Hz), 720x408, 640x360,
480x270, 320x240, 320x180
Four Stream
Resolution
1024x576, 960x540, 720x576 (50Hz),
720x480 (60Hz), 720x408, 640x360, 480x270,
320x240, 320x180
Video Bit Rate 32Kbps ~ 102400Kbps
Bit Rate Type Variable Rate, Fixed Rate
Frame Rate 50Hz: 1fps ~ 25fps, 60Hz: 1fps ~ 30fps
Audio Compression AAC
Audio Bit Rate 96Kbps, 128Kbps, 256Kbps
Protocols TCP/IP, HTTP, RTSP, RTMP, ONVIF, DHCP, etc.
Input/Output Interface
HD Output
1 x HDMI Version 1.3
1 x 3G SDI: BNC type, 800mVp-p, 75Ω,
SMPTE 424M standard

Network Interface 1 x RJ45: 10M/100M Adaptive Ethernet Port
Audio Interface 1 x LINE IN: 3.5mm Audio Interface
Communication
Interface
1 x RS232 IN: 8pin Min DIN, Max Distance: 30m,
Protocol: VISCA / Pelco-D / Pelco-P
1 x RS-232 OUT: 8pin Min DIN, Max Distance: 30m,
Protocol: VISCA network use only
Power Jack JEITA type (DC IN 12V)
Physical Parameter
Input Voltage DC 12V
Current Consumption 1.0A (Max)
Operating Temperature -10°C ~ 40°C
Storage Temperature -40°C ~ 60°C
Power Consumption 12W (Max)
MTBF ＞30000h
Size 200 x 150 x 165mm/7.87” x 5.91” x 6.50”
Net Weight 1.6 kg / 3.53 lb

Panel Description
Item Name
1 System Select Switch
2 Network Interface
3 RS232 OUT Interface
4 RS232 IN Interface
5 HDMI Interface
6 LINE IN Interface
7 3G SDI Interface
8 DC 12V Interface
9 Power Switch

Dimensions

Installation and Wiring
Installation
To mount camera on a wall, please follow the following wall mounting
installation steps.

Safety Precautions
Electrical Safety
Please install and operate this product in accordance with all electrical safety
standards.
Use caution to transport
Avoid stress, vibration or liquid damage in transport, storage and installation.
Power supply polarity
This product uses a +12V power supply with 1.5A max electrical current.
Installation Precautions
Do not hold the camera lens when carrying it. Mechanical damage may be
caused by touching camera lens by hand. Do not use in corrosive liquid, gas
or solid environments to avoid plastic cover damage. Make sure there are no
obstacles within rotation range. Do not power on before installation is
completed.
Do not disassemble camera
We are not responsible for any unauthorized modification or dismantling.
Specific frequencies of electromagnetic fields may affect camera
image performance.

Device Wiring
1. Please check connections are correct before starting.
2. Connect the power adapter to the power connector on the rear panel of
the camera. The power indicator on the front panel of the camera will
turn on.
3. After the camera is powered on, it will initialize by moving to its limits,
then returning horizontally and vertically to the middle position. The
initialization is complete when the motor stops running. (Note: If preset 0
is saved, PTZ will move to preset 0.)

IR Remote Control
Key Description
1. Standby Key
Press this button to enter standby mode. Press it again to enter normal mode.
Note: Power consumption in standby mode is approximately half of normal
mode
2. Number Key
To set preset or call preset.

Key Description
3. *Key
Used with other buttons.
4. Preset Key
Set preset: Store a preset position.
[SET PRESET] + Numeric button (0-9): Setting a corresponding numeric key
preset position.
5. HOME Key
Confirm menu selection; Returns PTZ to the middle position when pressed.
6. Return Key
Return to previous level menu.
7. Zoom Key
Slow Zoom: Zoom In [+] or Zoom Out [-] slowly.
Fast Zoom: Zoom In [+] or Zoom Out [-] quickly.
8. Left/Right Setting Key
Press with 1 button and 2 button to set the direction of the Pan-Tilt.
•Simultaneously press L/R Set + 1 [STD]: Turns Pan-Tilt in same
direction as the L/R Set.
•Simultaneously press L/R Set + 2 [REV]: Turns Pan-Tilt in opposite
direction as the L/R Set.
9. Focus Key
Used for focus adjustment.
Press [AUTO] to adjust focus on the center of the object automatically.
Press [MANUAL] to adjust focus on the center of the object manually.
Use [FAR] to focus on distant object and [NEAR] to focus on close object.
10. Selection Key
Press the button corresponding to the camera to be operated with the remote
controller.
11. #Key

Key Description
Used with other buttons.
12. IR Remote Control Key
[*]+[＃]+[F1]: Address 1
[*]+[＃]+[F2]: Address 2
[*]+[＃]+[F3]: Address 3
[*]+[＃]+[F4]: Address 4
13. Reset Key
Used to erase a preset position.
[RESET] + Numeric button (0-9)
Or: [*] + [#] + [RESET] to erase all presets.
14. PTZ Control Key
Press arrow buttons to pan and tilt. Press [HOME] button to return the camera
to default position.
15. Menu Key
Press to enter or exit OSD MENU.
16. Backlight Key
Press to enable or disable backlight compensation.
NOTE:
•Effective only in auto exposure mode. Use when lighting behind
subject darkens the image.
•Backlight compensation will improve the image, and can be canceled
by pressing [BACKLIGHT] button again.
17. PTZ Reset Key
Preset Pan/Tilt self-test.