DVS ECO15 User manual

DVS Filtertechniek
Aan de Fremme 53 B
6269BK Margraten
www.dvs filtertechniek.com
info@dvs filtertechniek.com
QUICK GUIDE
v1.4
DVS FILTERSYSTEMS

2
QUICKGUIDE
Index
1 BASIC REQUIREMENTS .............................................................................................. 3
1.1 Control unit .............................................................................................................. 4
2 A. GRAVITY-SYSTEM .................................................................................................. 5
2.1 Placing the filter system .......................................................................................... 5
2.2 Set level control: ..................................................................................................... 8
3 B. PUMP FED SYSTEM ................................................................................................
3.1 Placing filter system ............................................................................................... 9
3.2 Set level control: ................................................................................................... 11
4 WATER VALVE ( PLC) ............................................................................................... 12

3
QUICKGUIDE
1 Basic requirements
Basic requirements every filter system must meet:
 The filter system should be placed on a ground surface with sufficient carrying capacity, for instance:
− a well vibrated sand bed of 10 cm, possibly with concrete tiles
− a concrete floor
In the event of subsidence, the filter may not function properly!
 The filter system should be placed fully level.
 Leave sufficient space around the filter, to perform cleaning and maintenance work.
 The filter control should be in a dry area, preferably indoors.
 The drive motor must be protected against weather influences.
The filter system can be used as gravity system or pump fed system.
IMPORTANT!
The correct placement and constant water level in the pond are important
conditions for optimal and problem-free operation of the filter system.
.
IMPORTANT!
The use of salt in the pond can cause stainless steel components of the filter to
oxidize.

4
QUICKGUIDE
1.1 Control unit
Power Switch
Manual Cleaning
Plug Sensor
Plug
M
otor
Drumfilter
Plug
Circulation Pump
Plug
Cleaning Pump

5
QUICKGUIDE
2 A. Gravity-system
2.1 Placing the filter system
 Determine the maximum water level of the pond.
 Align the base plate horizontally (the filter should be placed fully level).
 The filter should be placed the height of the installation height (fig. 2.1) above water level.
(installation height is the distance from maximum water level to top of filter).
Type filter Installation height
[cm]
ECO15
16
ECO22
16
PP22
17
PP35
17
PP50
17
PP65
17
PP100
18
PP100n
1
8
D22
17
D50
12
C22
14
CL15
14
CL22
14
CL35
14
CL50
14
CL65
14
GRAVITY

6
QUICKGUIDE
Schematic setup of the drum filter
Pic. 2.1
1. Water level with running pump after rinse (short pen 8 cm in water)
2. Start rinsing
3. Pond pump switches off
4. Installation height PP is 17 cm
GRAVITY

7
QUICKGUIDE
Schematic setup of the combi drum filter
Pic. 2.2
1. Water level with running pump after rinse (short pen 8 cm in water)
2. Start rinsing
3. Pond pump switches off
4. Installation height CL is 14 cm
GRAVITY

8
QUICKGUIDE
2.2 Set le el control:
 For the operation of the gravity system a constant water level in the pond is necessary.
A tolerance of up to 20 mm below maximum water level is allowed.
 Should the maximum water level in the pond exceed this, the water excess water will be disposed of via the waste water drain,
until the maximum water level has been reached
For more detailed information you are referred to the complete manual.
This can be found at www.dvs filtertechniek.com
GRAVITY
Pic. 2.3 Sensor
1. Water level with running pump after rinse
(short pen 8 cm in water)
2. Start rinsing
3. Pondpump switches off
Pic. 2.4 Float switch (ECO models / models With PLC controller)
1. Water level with running pump after rinse
2. Start rinsing

9
QUICKGUIDE
3 B. Pump fed system
3.1 Placing filter system
 Determine the maximum water level of the pond
 Align the base plate horizontally (the filter should be completely level).
 The drumfilter must be placed 30cm higher than the biochamber.
(the distance from top of the drumfilter, to the top of the biochamber is 30cm)
Schematic setup of the drum filter
Pic. 3.1
1. Water level with running pump after rinse
2. Start rinsing
3. Pond pump switches off
PUMP FED

10
QUICKGUIDE
Schematic setup of the combi drum filter
Pic. 3.2
1. Water level with running pump after rinse
2. Start rinsing
3. Pond pump switches off
PUMP FED

11
QUICKGUIDE
3.2 Set le el control:
For more detailed information you are referred to the complete manual.
This can be found at www.dvs filtertechniek.com
PUMP FED
Pic. 3.3 Sensor
1. Water level with running pump after rinse
2. Start rinsing
3. Pond pump switches off
Pic. 3.4 Float switch (ECO models / models With PLC controller)
1. Water level with running pump after rinse
2. Start rinsing

12
QUICKGUIDE
4 Water Valve ( PLC)
Automatic refill
Waste cleaning
P
Pond
GUTTER