Dyer D+H RCT 003-11-U User manual

RCT 003-11-U instructions
Intended use
1x Radio control transmitter
1x Connection cable
Scope of supply
- Radio control transmitter for controlling of
D+H radio drives and radio control receivers
- Installation behind a vent button in standard
wallbox
- Connection of two vent buttons possible
- Input 2 is in conjunction with the VENTIC
solar also suitable for connecting a room
temperature controller (RTR 231)
- Long battery life
- For VENTIC-Solar, GVL 8401-K-RC,
BDT 010-RC and
-Radio frequency 868 MHz – approved in the
entire EU
- 128 Bit AES coding
- High reliability against external operation –
32 Bit address codification and alternating
code with every keystroke (Code-Hopping)
- Multiple drives controllable with
one radio control transmitter
RCM xxx-11-U
Technical Data
Radio frequency :868,3 MHz / FSK
Encryption :AES / 128 Bit
Radio standard :ETSI EN 300220-1:2010
:ETSI EN 301489-1:2011
:ETSI EN 301489-3:2002
Transm. power :app. 4 mW (e.r.p.)
Transm. range :up to app. 100 m (free field)
Material :ABS, POM
Dimensions :45 x 39 x 12 mm WxHxD
Battery type :1x lithium CR 2450
LT
RCT 003-11-U
03
PI
30.212.00
C°05+..
.C°0
:.pmeT
RCT 003-11-U
OPEN
1x CR2450
ON
2 1
TEST
2 1
ANT
OFF
S1 19
www.dh-partner.com
87 6 5 4 3 2
Connection
LT 84-U
RTR 231
(only with
VENTIC-Solar)
5
LT 84-U
P
< optional >
see DIP switch
S1-1 page 2
Antenna
Insulate not used lines.
1
3
P
ST OP

ST OP ST OP ST OP
VENTIC-Solar
GVL 8401-K-RC
RCM xxx-11-U
BDT 010-RC
etc.
YE = =
GN = =
= =
RD = =
STOP
Pairing radio control transmitter
>
5
Sec.
>
2
Sec.
1x
Exit
5
Sec.
5
Sec.
5
Sec.
5
Sec.
Level 1
Level 2
5
Sec.
5
Sec.
Level 3
Start
LT
LT
Battery replacement
Li
SET / S1
VENTIC-Solar
GVL 8401-K-RC
RCM xxx-11-U
BDT 010-RC
etc.
SET
VENTIC-Solar
GVL 8401-K-RC
RCM xxx-11-U
BDT 010-RC
etc.
ST OP
Operation
CR 2450
3V
Test mode
Transmission mode for testing the connection
quality between the radio control transmitter and
receiver for about 15 min. (LED flashes on the
connected receiver). Abort by pressing the button
again.
The test mode must not be activated.
For RTR 231: The drive must be programmed to „storage“ operation.
Antenna
ST OP
entspricht /
equivalent
0
right stop
ST OP
entspricht /
equivalent
Antenna
~ 35 mm
Für / for RTR 231:
>
5
Sec.
VENTIC-Solar
GVL 8401-K-RC
RCM xxx-11-U
BDT 010-RC
etc.
RTR mode
S1-1 = ON
(Input 2 = RTR)
S1-1 = OFF
(Input 2 = LT)
S1-2 : idle
RCT 003-11-U
ON
2 1
TEST
2 1
ANT
OFF
S1 19 87 6 5 4 3 2
ST OP
2 1
ST OP ST OP
Only in conjunction with VENTIC-Solar
(from calendar week 32-2014) possible!
2
Sec.
2
Sec.
RCT 003-11-U
0
left stop
ON ONOFF OFF
Dyer Environmental Controls Ltd
Unit 10 Lawnhurst Trading Estate, Cheadle Heath,
Stockport SK3 0SD
Tel: [phone]
E-Mail: [email protected]
www.dyerenvironmental.co.uk