Dynam DY8965 Guide

DYT-2002 4CH Transmitter
DIRECTIONS FOR ASSEMBLY AND ADJUSTMENT
CENTER OF GRAVITY(C.G.)
40 45 40 45
5
6
DY8965 Rapid
1
3
7
8
4
29
10 11
14 15
12 13
DECAL:
5
7
6
1
32
4
8
glue
2 Install the landing gear with PM3*25mm
screws.
1 Install the wing with PM3*25mm screw. 3 Apply some glue on the contact area on the
elevator. Glue the elevator onto the fuselage.
4 Install the elevator push rod as shown.
5 Install the rudder push rod as shown. 7 Glue the spinner.
Install the propeller.
6 8 Open the canopy this way.
DY8965
Wingspan
Length
Flying Weight
Wing Area
Wing Load
Radio System
Power
Battery
: 635mm (25in)
: 627.5mm (24.7in)
: 330g (11.7oz)
: 8.1dm²
: 40.7g/dm²
: 4 Ch TX and 7 Ch RX
: Brushless System
: LIPO, 800 mAh, 11.1V
ASSEMBLY:
DYA-0001/ 2 / 3 / 4
EU/US/KU/AU Adaptor
DYP-1021 7*6 Propeller DY-1100 3.7g Servo
Rapid-07 Push Rod Rapid-08 Servo Horn
Rapid-09 Prop Adaptor
DYE-1001 18A ESC
DYR-2002 2.4G Receiver
DYC-1002 Balance Charger
Rapid-01 Fuselage
SPARE PART LIST:
5
6
DY8965Rapid
1
3
7
8
4
29
10 11
14 15
12 13
Rapid-02 Wing Rapid-03 Elevator Rapid-04 Spinner
Rapid-05 Landing Gear Rapid-06 Plastic Tab
DY-6017 11.1V 800mAh 25C Battery
DY-3003 Glue
Brushless Motor BM2313 KV1500 BM2313 KV1500-Shaft Motor Shaft
Rapid-10 Decal Rapid-11
Motor Mount
Control Throw Setting Suggestion
Elevator Aileron Rudder
11.1V 800mAh
Li-Po, 25C
(7x6)
ESC-18A
ESC-18A
Lithium-polymer Battery
800mAh 11.1V
25C Discharge
Rechargeable Cells
Use li-po charger only
MOTOR
Dynam RC
dynam-rc.cn
of
This product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. Please recycle.
over
Rapid-12
Battery cover
Rapid-13
Screw set