Dynam SR Trainer User manual

2

RTF INCLUDING
3
RTF including:
fuselage
wing
elevator
landing gear
Landing pole
plastic parts set
push rod
glue
decal
balance charger
LI-Po battery (11.1V 2200mAh 20C)
transmitter
Adaptor
Propeller
ESC

4
As shown, coated adhesive foam
rubber in the horizontal tail Office.
As shown, horizontal tail position in the
corresponding bonding fuselage.
As shown, the rudder rod penetration
quick connector, tighten with a
screwdriver.
As shown, the elevator rod penetration
quick connector, tighten with a
screwdriver.
this time steering the Huizhong state.
Indicate: this time steering the Huizhong state. Indicate:
Z-end of the rod will turn into plastic
pieces shown in the figure.
Fixed front wheel steering with PA2.5X6.

5
The front wheel steering rod into quick
connector fastened with a screwdriver.
this time steering the Huizhong state.
Indicate:
As shown,Tear up the surface layer
of the double-sided adhesive.
As shown,Install hood in the fuselage. As shown in the installation of 9060
Clover paddle
Phillips screwdriver fastening fairing.
.
As shown,Body antenna installation.

6
18
As shown, Left and right wing bonding.
As shown,Installation of plastic parts
in the position of the wing mark.
As shown,Landing gear screws around
with PA2.5X6.
As shown,The aileron cable with
Y-cable
As shown,Installation of wing and
fuselage, tighten with a screwdriver.
.
Bubble gum on the left and right
wing James.

THROTTLE
RUDDER
ELEVATOR
AILERONS
airplane action
airplane action
airplane action
airplane action
control plane
movement
control plane
movement
Aileron
movement
7
STICK OPERATION
MODE 1 MODE 2 MOVEMENT

9
3
78
13
1
5
6
4
11
2
10

10
Wire lead shorts can cause fire! If you accidentally short the wires, the battery must be
placed in a safe area for observation for approximately 15 minutes.
After flight, the battery cool down to ambient temperature before charging.
observation