
Using your microphone system 5
4Plug the other end of the audio cable into the MIX IN or AUX IN on an external
amplifier.
5Open thebattery compartment, install two AA batteries into the battery
compartment, then close the compartment. Make sure that the + and – symbols on
the batteries align with the + and – symbols inside the battery compartment.
6Slide the power switch to the ON position. The POWER indicator lights.
To install the microphone battery:
1Unscrew the battery cover.
2Insert the 9 V battery into the battery compartment. Make sure that the + and –
symbols on the battery align with the + and – symbols inside the battery
compartment.
3Slide the cover to close the compartment.
Using your microphone system
To use your microphone system:
1Turn on the receiver.
2Turn on the microphone.
3Adjust the volume on the amplifier, if necessary.
Troubleshooting
Caution: Do not open the open the receiver case or microphone housing. There are no user
serviceable parts inside.
Symptom Possible solution
Receiver is turned on, but POWER indicator
does not light. • Make sure that the power cord is plugged
in securely.
• Make sure that the electrical outlet is
supplying power.
The AUDIO indicator lights when speaking
into the microphone, but there is no sound. • Make sure that the volumecontrol on the
amplifier is not set too low.
• Make sure that the audio cable is
connected securely to the receiver and
amplifier.
DX-M1114.fm Page 5 Wednesday, May 17, 2006 2:45 PM