Dynex DX-M100 User manual

P/N: 2300-0245
5
6
7
56K Data/Fax/Voice Modem
Model No.: DX-M100
www.dynexproducts.com
Installation Guide
Part 4. Modem Dialing Location FCC Certifications
This device complies with Part 15 of the FCC rules. Operation
is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2)
This device must accept any interference received, including
interference that may cause undesired operation.
CE Mark Warning
This is a Class B product. In a domestic environment, this
product may cause radio interference.
Following the instructions below, you can change the dialing
location.
1. In Windows 2000/XP, Click Start Settings Control Panel
Phone And Modem Options Under Dialing Rules click
Edit, and then you can change your location.
2. In Windows ME/NT/98, click Control Panel Modem
Under General click Dialing Properties, and then you
can change your location.

2
DX-M100 56K Data/Fax/Voice Modem PCI Card
Driver & Application software CD-ROM
Quick Installation Guide
Package Checklist Part 1. Hardware Installation
With the power to your PC disconnected, remove the PC's
casing. Press the modem card firmly into the PCI slot, and
secure it with screws to your PC. Reinstall the casing on your
PC.
Part 2. Installation Procedures
1
In some case, Windows operating system will get the default
driver and install the modem automatically. Please follow the
process below to update the driver of your modem.
1. Find the modem from Start Settings Control Panel
System Hardware Device Manager Modem.
Double-click the modem description, e.g., Intel(R) 536EP
Modem. Click Properties.
2. Select Driver and click Update Driver.
3. The wizard will search for new driver. Select Don't search. I
will choose the driver to install and click Next.
4. Click Browse to search for driver files and open it, e.g., (CD
-ROM) D:\DRIVER\WINxx. Click OK and then click Next.
5. Click Finish.
Part 3. Update Driver
3 4
DX-M100 supports the following communication standards.
ITU-T is also known as CCITT.
Features
Driver installation for Windows O/S
The following instructions apply for Windows 98, 98SE, ME, NT,
2000 and XP. Some of the screens may differ slightly across
operating systems.
1. Once the device is properly connected to your computer,
Windows O/S will automatically detect the new hardware
device. Click Next.
2. Select Search for the best driver for your device
(Recommended). Click Next.
3. Insert the device driver disk into your CD-ROM. Select
Specify a location, and click Browse to search for driver
files and open it, e.g., (CD-ROM) D:\DRIVER\Winxx. Click
Next.
4. Windows found the driver of this modem. Click Next.
5. Click Finish to complete the installation.
6. Wait until the drivers were installed automatically.
Note: Windows will notify you that the driver has not passed
Windows Logo testing. This is normal, and it has been
verified that the Adapter does work with Windows XP.
Click Continue Anyway.
Data
V.92 (Lite)
V.90, V.34, V.32bis, V.32
V.22bis, V.21
V.22Bell 103 & 212A
V.44, V.42bis & MNP 5 (Data compress)
V.42 & MNP2-4 (Error correction)
Fax
V.17 (14,400bps)
V.29 (9,600bps)
V.27 (4,800bps)
Voice
Voice/Audio mode
Speaker/Phone jack