E.C. Woods CALISTOGA COFFEE/END TABLE User manual

Assembly Instructions E.C. Woods, Inc. Outdoor Furniture
CALISTOGA COFFEE/END TABLE
STEP 1: (a) Lay all pieces on a smooth soft surface such as cardboard or carpet to help avoid scratching. We suggest
using a 6” #2 square drive bit to fasten all screws (available at your local hardware store). Be careful to not over
tighten any of the fasteners.
(a)
Tools Needed
Cordless Drill
6” #2 Square Drive Bit
Tape Measure

STEP 2: (b) Place one of the side assemblies with the wider legs on a clean soft surface with the pocket holes facing up
(c) (If you are assembling the coffee table go to STEP 4 (f) first) Line up the outside of the end assembly with the
outside of the side assembly and then fasten the end assembly thru the countersunk holes to the side assembly using
the 1 ½” stainless steel round head screws provided.
(b) (c)
STEP 3: (d) Place the table top on a clean soft surface upside down and center the completed leg assembly upside down
on the bottom of the table top. (e) Fasten the leg assembly to the table top using the 1 ½” stainless steel round head
screws provided.
(d)(e)

STEP 4: Coffee Table ONLY (f) Remove the aluminum reinforcing strips from the side assembly and set off to the side for
later use. (g) Install the reinforcing strips using the 5/8” stainless steel round head screws provided.
(f) (g)
ecwoutdoorfurniture.com