e-motion H User manual

E-Motion Model H Setup
Your rollers ship fully assembled. All you need to do is make a simple
adjustment to fit your bike. Refer to the diagram here, hich sho s the
proper position of the front drum, directly centered beneath the front
heel of the bike.
Note: the rollers ill only ork for bikes ith a heelbase bet een 36.5
and 42.5 inches
Step 1 Step 2
Step 1 : Loosen both hand knobs located on the ends of the front drum.
Step 2: Rotate the index knobs to move the drum. They are located in slots
next to the front drum. You may rotate both of them at the same time OR
alternate from one side to the other, one turn at a time. After you have
moved the drum to the desired location, place the bike on the rollers and
visually check the position.
Step 3: Tighten the hand knobs.

E-Motion Model H Setup
Resistance adjustment
Your rollers are fitted ith a magnetic resistance unit hich may be set to 4
different positions. Rotate the arm as sho n to the numbered stops. The zero
number is “off” and the resistance goes higher for the each of the settings 1
thru 3
Wattage Chart
Insideride.com