Eaelec GMC CCKW 2 1/2 ton Tanker Truck User manual

Assembly Instructions For TT-Scale
GMC CCKW 2 ½ ton Tanker Truck
Page 1
Introduced in April 1943 the canvas
covered cab version of the CCKW military
truck replaced the earlier metal closed cab
type. Over 155,000 of these trucks were
produced. This kit is the fuel tanker version of
the CCKW. This model is available with or
without the winch mounted behind the front
bumper.
Parts Included in the kit:
A. 3D printed chassis
B. 3D printed cab
C. 3D printed tanker bed
D. One decal sheet
Required to complete the kit:
Paint - Flat black, flat steel, canvas,
glosscoat, dullcoat
and Flat army olive (Testors 1165 or
Tamiya XF49)
Glue - Slow setting CA is best.
www.eaelec.com
Decals Printed in the USA
Made in Canada
WARNING: CHOKING HAZARD
Keep out of reach of small
children!
Note that these ARE NOT TOYS,
AND ARE NOT INTENDED FOR
USE BY CHILDREN UNDER
AGE OF 14. These products are
model railroad equipment and
accessories intended for use by
adults.
CCKW Fuel Tanker, Painting & Decal Placement
Decal
Decal
Decal
Top View
Left View
Right View
Olive
Olive
Canvas
Canvas
Olive
Decal
Decal
Flat Black
Flat Black
Olive Olive
Flat Steel
Flat Steel
U.S.A. 4352967
U.S.A. 4352967

The 3D printing process requires a supporting frame during printing, see below left. The
printed part is cut from the frame using flush cutters and this sometimes leaves small bumps on the
part. Use a knife with a sharp new blade to cut away the bumps. When trimming bumps off the
wheels you should place the wheel on a flat surface as shown below on the right. Putting too much
stress on the wheel can cause the axle to break. For bumps on the cab body, sanding is
recommended.
Page 2
www.eaelec.com
When gluing the cab to chassis, front
of the cab should extend to red line
After cleaning up the bumps, paint the both the cab and the tanker bed flat olive and the entire
chassis flat black. Once these have dried paint the wheel hubs, fuel tank and front bumper olive
using a fine brush (see painting guide on page 1). If truck is equipped with a winch, paint the winch as
shown below. Apply a coat of gloss to the cab, let dry and then place the decals as shown on guide.
After the decals are completely dry, apply dullcoat to the cab.
When everything is dry, assemble the truck as shown below using CAglue.
Step 1 - assemble the tanker bed:
Step 2 - glue cab & tanker bed to chassis: