Eagle E370B User manual

E370B
2 Gang Floor Socket 13A
Product Manual

IMPORTANT
Installer and Users please note: These instructions should be read carefully before use and this document
constitutes part of the product which should be kept safely by the user alongside the product.
BEFORE USE
You must inspect the device for any signs of damage. If the product is damaged, DO NOT use it, and contact
your supplier immediately.
PRODUCT SAFETY
Children shall not play with the device.
Cleaning and user maintenance shall not be made by children without supervision.
For indoor use only.
Do not use the appliance for other than its intended use.
Check the product before use for damage. If any damage is detected stop using it immediately and consult
your supplier.
GENERAL SAFETY REQUIREMENTS
Domestic wiring must be tested periodically by a qualified electrician at least once every 10 years or at every
change of occupancy. For office and retail premises (and buildings such as village halls) the wiring must be
inspected at least once every 5 years. It is recommended that all buildings be fitted with smoke alarms (it is
mandatory for new buildings).
GENERAL INSTALLATION INSTRUCTIONS
1. Ensure power is completely disconnected before attempting installation.
2. If using the new product to replace an old one, note the cable connections an wire up the new
product in the same way as the old one, with Earthing as stated in these instructions.
3. Ensure the mounting box (metal or patress) for either flush or surface mounting is the appropriate
size for the product.
4. Route the cable through the most suitable entry point of the mounting box. If a metal box is used, a
protective cable grommet should be used.
5. Cables should be prepared so a sufficient conductor length reaches the terminal. Strip the ends of the
individual conductors so that an adequate length enters the terminals.
6. Carefully arrange the wiring to lie along the edges of the product or box, keeping the central area
clear.
7. To assist with the correct installation, please consult the wiring diagram in these instructions.
8. When connecting the new accessory, ensure that only the bare end of the wire enters the terminal
and no bare wires are visible. Always tighten the terminal screws securely, but do not overtighten. An
earth connection should always be made between the mounting box earth terminal and the accessory
earth terminal, where fitted. If this earth wire is bare, it is essential that it is sheathed with a length of
green/yellow sleeving.
9. Carefully position the accessory into the wall box, ensuring that no wires are trapped between the
plate and the wall. Do not over tighten the screws. (Fit screw covers/clip on front plate as
appropriate).
10. Once work has been completed correctly, replace the fuse for the circuit, switch the power back on
and test. The product is now ready for use.

WIRING DIAGRAM
SERVICE WARRANTY
Eagle guarantees the product free from defects in materials and workmanship for a period of twelve months.
Should this appliance be operated under conditions other than those recommended, at voltages other than the voltage
indicated on the appliance, or any attempts made to service or modify the appliance, then the warranty will be rendered void.
The product you buy may sometimes differ slightly from illustrations. This warranty is in addition to, and does not affect, your
statutory rights.
Our guarantee is administered by our retailers.
If your product arrives damaged, you must contact the retailer from whom you bought it. The retailer's contact details will be
on the invoice that arrived with the product, or on the e-mail you received when you placed the order. Do not contact Eagle,
only your retailer can arrange a replacement.
If your product fails within the guarantee period, firstly read the "fault finding" section of this manual, because temperature
and weather conditions can affect the performance of certain products. If the product needs to be repaired or replaced, you
must contact the retailer from whom you bought it.
If you have just received your product and require technical help using it, please call our Help Desk on [phone]
If you have any other technical queries about the product, please call our Help Desk on [phone]
Electrovision Ltd.
Lancots Lane, Sutton
St. Helens, Merseyside
WA9 3EX
www.Electrovision.co.uk
NOTE: EXACT POSITIONS OF LIVE, NEUTRAL AND EARTH TEMINALS MAY VARY! ENSURE THE CORRECT CABLE IS CONNECTED
TO THE CORRECT TERMINAL BY CHECKING THE LETTER NOTATION ON THE TERMINAL (E, N, L)